Instapak 901 Machines Foam in Place Systems Sealed Air, US $700.00 – Picture 0

Instapak 901 Machines Foam in Place Systems Sealed Air, US $700.00 – Picture 1

Instapak 901 Machines Foam in Place Systems Sealed Air, US $700.00 – Picture 2

Instapak 901 Machines Foam in Place Systems Sealed Air, US $700.00 – Picture 3

Instapak 901 Machines Foam in Place Systems Sealed Air, US $700.00 – Picture 4

Instapak 901 Machines Foam in Place Systems Sealed Air, US $700.00 – Picture 5

Instapak 901 Machines Foam in Place Systems Sealed Air, US $700.00 – Picture 6

Instapak 901 Machines Foam in Place Systems Sealed Air, US $700.00 – Picture 7

Instapak 901 Machines Foam In Place Systems Sealed Air

US $700.00

Attalla, Alabama, United States
Jan 31st

Open on mobile:
QR code

For sale is three sealed air brand foam in place machines. Chemicals are NOT included. You are getting everything in the pictures except chemicals. We had one of these units in production until about nine months back. We purchase 2 other units used when our original unit failed with a error code to try and keep it running. Now the last Part A hose appears to have failed and we are selling everything. If you buy these units and you have never used one or worked on one before you are going to have trouble! They are messy and the parts from Sealed Air are out of sight expensive. List of what is included: (1)901 system with cables and controllers - inop (2) 970 system with cables and controllers - missing parts - inop As far as I remember all the cables are complete and in good condition except one has a burn on it. (1) full gallon of gun cleaner Partial roll, about 1/2, of plastic for the foam. The controller for the 901 has a error code coming up about temperature in a hose, a controller for the 970 was used to replace it and not much investigating was done. The other 970 controller was never hooked up. The 970 controllers "appear" to be the same as the 901 controller and it worked in our system for a 970 to control the 901 pumps. Both of the Part A pumps from the 970 system need repair due to the part A chemical hardening inside them. One of the 970 pumps is missing parts and possibly the other 970 pumps is missing parts. There was only one working gun and it might have problems too, I don't remember. The other two guns are missing the stainless steel plunger at the tip. Plus filters inside the these two guns have been robbed. Included is three hose and cable hangers. These are the crescent moon looking things about 24" long. They attach to the spring hoist pictured and allow you to pull the gun down to your box and then when done it pulls itself back up out of the way. The difference between the 901 and 970 systems. They are basically the same. The pumps for the 901 are permanently attached to tubes that go down inside the drums. The pumps are mounted on a shaft at the bottom of the tube in the chemical. Both the 901 pumps were working fine when the hose failure occurred so I expect them to be good but can't say for sure. The 970 pumps mount on the wall above the drums and a hose is attached to them that runs down into the chemical. The 901 is much more common and may be the only type offered now by sealed air. If I remember correctly and that is a big if, you will need to purchase at least a new Part A hose with the heater and probably some gun parts. There is a heater element that runs the full length of the part A and part B hoses. You might be able to use the Part B hose on the Part A side - not sure. But like I said earlier, if you have never worked on these units before this would not be a good one to start with. Shipping - For the units without the chemicals weight is about 300 pounds. I will send you a quote if requested or we can ship on your account. Estimated shipping cost- SE USA = $150.00; NE USA = $220.00; MW USA = $250.00; West USA = $300.00 Call 256-528-7120 for more info. Buyers: Potential buyers registered outside the USA must get approval before bidding UNLESS the listing indicates them as a ship to location. Most small items are now available for Worldwide shipping. At store pick up and shipping: There is no charge for on-sight pickup. Please note: All items should be professionally inspected and tested prior to installation or use. We are not liable for damages, injuries or death relating to our products. All items are described based on our observation to the best of our ability, we are not experts on all the items we sale, assume all items to be untested unless stated otherwise. We usually ship same day or at the latest 2 business days after receiving payment. If you need something expedited please let me know. Payments: We accept Paypal and Credit Card payments- Credit Cards CAN ONLY be accepted over the phone. We reserve the right to refuse payment from buyers registered in foreign countries or locations with non corresponding ship to addresses. Additionally, we reserve the right to refuse payment from any buyer which will feel is acting in a possible malicious manner. Feedback: Once you are satisfied with your purchase please leave us feedback INV B Powered by eBay Turbo Lister The free listing tool. List your items fast and easy and manage your active items.

Condition	For parts or not working : An item that does not function as intended and is not fully operational. This includes items that are defective in ways that render them difficult to use, items that require service or repair, or items missing essential components. See the seller’s listing for full details.
Seller Notes	“Lots of good parts”