ISD1760 voice board voice recording sound module on-board microphones, US $7.65 – Picture 0

ISD1760 voice board voice recording sound module on-board microphones, US $7.65 – Picture 1

ISD1760 voice board voice recording sound module on-board microphones, US $7.65 – Picture 2

ISD1760 voice board voice recording sound module on-board microphones, US $7.65 – Picture 3

Isd1760 Voice Board Voice Recording Sound Module On-board Microphones

US $7.65

shen zhen , China
Jun 9th

Open on mobile:
QR code

ISD1760 voice board voice recording sound module on-board microphones 1. onboard chip ISD1760 2. onboard microphone, you can record directly 3, can be 75 seconds or so voice recording 4, with recording, erase, play, FT straight, fast forward, reset, volume control and other functions 5, the chip has led major pin can be controlled by the microcontroller operation 6, high-quality natural voice restored, the module can be used as propaganda 7, the working voltage: 5V 8, board size: 49 (mm) x41.5 (mm) Key Description 1. Recording REC: Press and hold the REC key while LED lights up, this time facing the MIC speak, speak content will be recorded into the ISD1700 voice chip in it. After recording some lift this key, LED will also turn off, press again to start recording the second paragraph, after paragraphs were operating. 2. Playback PLAY: There are two ways, edge-triggered and level-triggered. (Note: After recording playback pointer will stay in the starting address of the last segment of the finished recording, playback at this time is to put the last paragraph) (1) Edge: Click the PLAY button that put the current segment, LED flashes during playback until the playback ends off. Playback after playback pointer to the end of the start address of the segment just put in, click the PLAY button will put just finished put this again. (2) Level Trigger: the chip will often press the PLAY button all Play all voice messages, and this cycle until you release the button. 3. Fast forward FWD: Before performing playback operation, click this button playback pointer will point to the next section, double-click the starting point to the second paragraph after paragraph. Click this button during playback to stop playback of the current segment and then play the next paragraph, if the last paragraph is currently playing, stop playing the last paragraph of play in the first paragraph. 4. ERASE ERASE: Single segment erase operation can only be effective on the first and last paragraph, when the playback pointer is the first or the last paragraph, the key point here is to erase the first or the last paragraph. Playback cursor will jump to the corresponding second or penultimate paragraph before erasing. Normally this key more than 3 seconds chips into the "Erase all modes of operation," while LED lights flash twice, continue pressing this button, LED blinks off after 7 under, then release the button, voice messages within the chip is All erased. 5. Reset RESET: Click this button to reset the chip to perform the operation. After reset, play and record pointer points to the last paragraph, that the last paragraph of the playback pointer to start recording a pointer to the last paragraph of the last. Run the playback is played in the last paragraph, the last paragraph and then execute it to start recording a new record last paragraph. 6. Tuning VOL: Click this button to adjust the size of the chip output sound. The default is the maximum sound output of the chip, according to every tap, sound attenuation by 4db. Until the smallest sound, continue to click this button, press each click, the sound increases 4db (Note: After the reset, the sound output is the maximum). 7. FT passthrough operations: The FT pin and GND shorted, will continue to remain low start passthrough mode. Passthrough operations will have direct access voice output from the speaker or AUD Analn end. During recording, if you press the FT, will also record incoming voice signal Analn. shipping list:1pcs ISD1760 voice board voice recording sound module on-board microphones

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Brand	Unbranded/Generic
Country/Region of Manufacture	Hong Kong