Line Tap Valves "solder On Style" For 1/4" O.d. Tube

US $340

Hartford, Wisconsin, United States
Jun 3rd

Open on mobile:
QR code

SquareTrade © AP6.0 JB Industries Part# A32804 1/4" Flare Piercing Valve For 1/4" O.D. Tube COPPER TO COPPER LINE TAP VALVES Approved by Leading Manufacturers for ALL types of refrigerants Eliminates costly, high-temperatue brazing Installed with 95/5 or or lead free low-temperature solder Consists of; Saddle body Line piercing pin Valve core Sealing cap Valve is kept closed by spring loaded valve core. Put sealing cap on for permanent seal Listing is for (1) Valve MADE TO INSTALL ON A CHARGED LINE! Follow directions below. INSTRUCTIONS: 1) Clean tubing, apply flux and solder saddle valve body onto line for leak proof joint. 2) Allow joint to cool, clean joint and check valve for leaks 3) Screw cap down on body forcing pin ti pierce line and crimp body. Use back wrench to avoid breaking braze joint. Tighten until body is crimped smoothly over top of pin. 4) Remove cap, attach hose and perform service. 5) When service is complete, wrench tight. COPPER SADDLE BRAZE/ TAPPER TUBE SIZE 1/4". THE NEW A32800 SERIES OF SADDLES OFFER THE BEST PROTECTION FROM LEAKS. ONCE BRAZED ON, YOU CAN CHECK FOR LEAKS BEFORE PIERCING THE TUBE. THE STEEL PIN IS INSERTED AND THE CAP IS TIGHTENED DOWN TO PIERCE THE TUBE. BODY SIZES ARE CONTOURED TO MATCH SPECIFIC TUBE SIZES. THE BRAZE/ TAPPER HAS AHARDENED STEEL-PIERCING NEEDLE AND IS FURNISHED IWTH A CAP. JB MACHINES ALL OF THE ACCESS VALVES AT THE FACTORY IN AURORA, ILLINOIS USING THE HIGHEST LEVEL OF BRASS CONSISTING OF 65% COPPER AND 35% ZINC. THIS GIVES OUR ACCESS FITTINGS A HIGH TENSILE STRENGTH WHILE RESISTING CORROSION. MANY IMPORT FITTINGS USE LESS QUALITY BRASS WITH LOWER COPPER CONTENT AND A HIGHER FAILURE RATE. JB MACHINES ALL OF OUR VALVES TO THE STRICT GUIDELINES OF THE ARI TO ENSURE PROPER SEALING OF THE VALVE AND CORE SURFACES. JB ACCESS FITTINGS HAVE GENEROUS COUNTER BORES TO ALLOW FOR THE REMOVAL OF THE CORE IF THE FLARE BECOMES DAMAGED. ALL TEES AND CROSSES ARE TAPPED TO RECEIVE AN ACCESS CORE IN ALL 1/4" SAE FLARE ENDS. ALL PIPE CONNECTIONS HAVE INTERNAL BRAZE CUPS FOR DIP TUBE APPLICATIONS. ALL VALVES ARE EQUIPPED WITH CAP AND ONE VALVE CORE (BRAZE TYPE, LOOSELY ASSEMBLED). TEMPERATURE RANGE -40 DEGREES TO +250 DEGREES FARHENHEIT (-40 TO 121.1 DEGREES CELSIUS). VALVE CORE IS STAINLESS STEEL AND BRASS FOR USE WITH ALL REFRIGERANTS INCLUDING R-410A. RESISTANT TO OILS, ALKALITES, AND DILUTED MINERAL ACIDS. MADE IN THE USA Check out my other items! Be sure to add me to your favorites list! Froo www.froo.com | Froo Cross Sell, Free Cross Sell, Cross promote, eBay Marketing, eBay listing Apps, eBay Apps, eBay Application