Mitsubishi Ed-2000m Edm Hole Driller, Edm Hole Popper Bore Holepopper

US $4500

Fort Worth, Texas, United States
May 26th

Open on mobile:
QR code

ED-2000M EDM Manual HOLE DRILLER, Max. Workpiece Dimensions 23.2" x 14.2" x 7.5". This machine was purchased new by our company new and used sporadically over the last few years. We just had the PCM sent off to Mitsubishi and had the battery replaced, re-programmed, and fully tested to make sure the machine functions properly. This machine comes with the step-down transformer, and all original documentation from Mitsubishi so it will be ready to use in your facility. Specifications: Machining Range X-Y-Z 11.8" x 7.8" x 7.8" W-Axis Servo Travel (electrode travel) 13.6" Max. Servo W-Axis Feed Rate 31.5"/min Electrode Diameter Range .012 ~ .120" Max. Workpiece Dimensions 23.2" x 14.2" x 7.5" Max. Workpiece Weight 330 lb. Table Dimensions W-D 13.7" x 9.8" Max. Electrode Length 16" Fluid Capacity 5 gal. Machine System Dimensions W x D 27.5" x 46.6" Machine Installed Height 71.8" Machine System Weight 880 lb. Control Operation Push Botton Touch Screen Power Supply Peak Current 30 AMPs Power Requirements [KVA] 200/220 VAC ±5% [2.5] Additional Features New Low-Energy consumption-type generator provides high-speed operation with extremely low electrode wear Patented low-voltage power supply produces no "bullet nosing" of the electrode providing cleaner hole break throughs Burn a 1.0 mm electrode though 2" thick D2 in 70 seconds Burn over 14 holes through 2" D2 with one electrode The control uses a full color touch-screen for easy operation Optional fluid tank / filter system extends fluid life Electrode chuck ranging from 0.3 ~ 3.0 mm diameter standard