Motortronics 200 Hp Soft Start

US $8,483.28

Big Lake, Texas, United States
Feb 24th

Open on mobile:
QR code

PRODUCT SPECS Power Components 6 SCRs in inverse parallel pairs for full phase angle soft start control 1600V PIV rating on all units RC snubber for dv/dt protection of each SCR pair Jog Dry contact closure selects a non-ramping Jog function at an adjustable torque Line Voltage Range 200 to 600 VAC, 3 phase +10% -15% on all units, 50/60Hz Kick Start 10 - 100% starting torque for 0.1 - 2 seconds Current Ratings 18 - 1250A depending on unit selection Range of each unit is 50-100% of maximum Pump-Flex™ Deceleration Ramp Fully adjustable to match field conditions: Begin Decel setting, 0 - 100% of line voltage Decel ramp time, 1 - 60 seconds End Decel setting (Off ), 0 - 1% of Begin setting AC Supply Voltage User supplied 120VAC +10% -15% tolerance, 60Hz Optional 240VAC 50Hz control available Restart Delay Timer (Sequential Start Delay) Programmable time delay 1 - 999 seconds after loss of control power for staggered restarts Overload Capacity (% of motor FLA) 500% for 60 seconds, 1.0 SF RS-485 Serial Communications Up to 247 starters per link Modbus RTU protocol built-in Full programming over the serial link Programmable remote starter control Bypass Contactor Standard on all units Standard Duty: Shunt rated bypass Heavy Duty (Across-the-Line) line start rated bypass Operator Interface Tactile feedback keypad Easy to read LED display Run and fault status indicators Start/Stop Control Choices 2-wire Run-Stop using dry contacts 3-wire Start/Stop with built-in seal in contact N.C. Interlock input (dry contact) for remote devices Electronic Shear Pin Protection Trip level: 100 - 300% of motor FLA with trip delay Ramp Control Choices (4 built-in) Voltage Ramp Voltage Ramp with Current Limit CLT© Closed Loop Torque Ramp (Current Ramp) Current Step (current limit only) Ramp times adjustable 1 - 120 seconds Current Limit adjustable 200 - 600% of FLA Motor Duty Cycle Protection Back-spin/coast-down, starts-per-hour or minimum time between starts lockouts. Restart delay after a power failure. Dual Ramps Select via dry contact closure between any combinations of the above Short Circuit Trips at 10x unit current rating during run. Checks for shorted load prior to each start. Start & Run Protection Two programmable overload trip curves allow for the thermal capacity required to start the load while providing motor overload protection needed during the run time. Start: Programmable for Class 5 - 30 Run: Programmable for Class 5 - 30, enabled when starter detects motor is "At-Speed" Reset: Manual or automatic, selectable via programming. Remote reset available. Shorted SCR Locks out on any single shorted SCR (defeatable) or can provide shunt trip function if multiple SCRs short or bypass contactor is welded closed. Real-Time Thermal Modeling Continuously calculates motor operating temperature even when the motor is not running. Metering Monitors phase current, ground current and motor thermal capacity. Retentive Thermal Memory Remembers the thermal condition of the motor even in the event of a power brown-out or black-out when power is restored. Extrapolates motor temperature using a real-time clock. Phase Loss Trips on phase current or voltage loss Dynamic Reset Capacity Overload will not reset until thermal capacity in the motor is sufficient for a successful restart. Starter learns and retains this information from previous starts. Phase Rotation Phase rotation trip can be set to A-B-C, A-C-B or disabled. Motor Temperature PTC thermistor input can also be used for E-stop or external overload relay. Equipment Ground Fault Residual current method with adjustable trip delay. Phase Current Imbalance/Loss Protection Trip level: 5 - 30% current imbalance between any two phases with trip delay

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Brand	Motortronics
Model	VMX-H