National Instruments SCB-68 Shielded Connector Block, NI 653X DIO Series Label, US $125.00 – Picture 0

National Instruments SCB-68 Shielded Connector Block, NI 653X DIO Series Label, US $125.00 – Picture 1

National Instruments SCB-68 Shielded Connector Block, NI 653X DIO Series Label, US $125.00 – Picture 2

National Instruments SCB-68 Shielded Connector Block, NI 653X DIO Series Label, US $125.00 – Picture 3

National Instruments SCB-68 Shielded Connector Block, NI 653X DIO Series Label, US $125.00 – Picture 4

National Instruments SCB-68 Shielded Connector Block, NI 653X DIO Series Label, US $125.00 – Picture 5

National Instruments Scb-68 Shielded Connector Block, Ni 653x Dio Series Label

US $125.00

Boise, Idaho, United States
Jan 29th

Open on mobile:
QR code

This listing is for one National Instruments (NI) SCB-68 Shielded Connector Block. Part # 182469-01B Rev B4, SN C1B366, and is same unit shown in photos. The unit is in very good condition, has some cosmetic scuffs and marks that won't affect function or performance. The device has 653X board signal reference label installed inside lid- this applies to the PCI-DIO-32HS, PCI-6533, PXI-6533, PCI-6534, PXI-6534, and any other compatible board configurations. Information from NI- The NI SCB-68 is a shielded I/O connector block for interfacing I/O signals to plug-in data acquisition (DAQ) devices with 68-pin connectors. Combined with the shielded cables, the SCB-68 provides rugged, very low-noise signal termination. It is compatible with single- and dual-connector NI X Series and M Series devices with 68-pin connectors. The connector block is also compatible with most NI E, B, S, and R Series DAQ devices. Shielded I/O connector block for use with 68-pin X, M, E, B, S, and R Series DAQ devices Screw terminals for easy I/O connections or for use with the CA-1000 2 general-purpose breadboard areas Onboard cold-junction compensation sensor for low-cost thermocouple measurements The SCB-68 will be well packaged and sent in box via USPS Priority Mail, insured. the tracking # will be entered into ebay and paypal systems after shipment.

Condition

Used :

An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. This item may be a floor model or store return that has been used. See the seller’s listing for full details and description of any imperfections.

Seller Notes

“This listing is for a used (new condition) SCB-68 shielded connector block in very good condition. The unit has some minor scuffs and marks which are cosmetic in nature and will not affect function or performance. The 68 pin connector is in excellent condition with all pins straight and extended, no pushed or bent pins. The device has jacksocket fasteners to attach to cable jackscrews to secure the connection. The breadboard area of circuit board is unused. The accessory comes with an 653X (DIO) signal reference label (compatible with PCI-DIO-32HS or PCI/PXI-6533, and PCI/PXI-6534) installed inside lid. The exterior side screws are not included. The bottom of unit has all four feet and labeling as shown in photos. The cable clamp is in excellent condition with no substantial indentations.”