Press For Repair/manufacture Sneakers And Cup-sole Shoe Pressing 15 Lb/sq.inch

US $1,749.00

Kharkiv, Kharkiv region, Ukraine
Jun 12th

Open on mobile:
QR code

This press is intended for the repair and production of sneakers, shoes and boots with bowl-shaped soles from 6 to 16 men's sizes. During pressing its diaphragm simultaneously pushes against and the bottom of the sole as well as the part that surrounds the upper of the shoe. The clamping force is adjustable and can be up to 15 psi. The press сonsists from the base, the air unit and the rack with a movable prop on it. On the base are located (from left to right): a pressure gauge showing the air pressure at the input of the press; pressure regulator in air unit; a gauge which shows in the air unit either a vacuum or a pressure in the air unit; 3-position switch, providing in the air unit either or vacuum or pressure. On the left side wall there is a connector for connection hose from the compressor. The use of the press is very simple and consists in the following. For pressing the surfaces to be bonded when the sole covers part of the top of the shoe (as in the case of sneakers): - connect the hose from the compressor to the press - making sure that the press receives air pressure (the left-hand manometer should show from 5 to 7 atmospheres), and to set the switch to the right position, "vacuum"; - when the diaphragm of the air chamber takes up the most concave position, move the switch handle to the middle position "off" - to shoe top, prepared for gluing, and dressed on the last, attach a sole prepared for gluing - put the workpiece in the cavity of the air chamber then lower the movable holder to against the stop to the last , and the pin to insert into hole of the last; - to set the switch in the "pressure" position; - after the desired time of gluing, to put switch in the "vacuum" position and when the glued shoe will in the free position, to retrieve it from the press. As for the price, it is the lowest possible, since the press is produced in the Ukraine. The production of one press by a qualified locksmith takes about 10 days using workshop equipment. In addition, the cost of parts and materials is around $ 180.

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Non-Domestic Product	No
Model	PSR-Universal-A
Modified Item	No
MPN	T.Technical Advantage Corp.
Country/Region of Manufacture	Ukraine
Brand	U.S. Solid
Custom Bundle	No
UPC	Does not apply