New Graco Used Oil Tank Monitoring System Automatic Pump Air Shutoff 116229

US $550.00

  • Broken Arrow, Oklahoma, United States
  • Feb 13th
Up for bid is a new Graco Used Oil Tank Monitor part # 116229 This is a new system starting bid is 399.00 these cost $ 700 to $ 800 online. I also have for sale new pumps, a tank, some used oil guns and hose reels. If you have any questions you may call or message Bob at 918-833-092seven Ships to lower 48 states for $18.99 For Remote Monitoring and Automatic Pump Air Shutoff 150 psi (1.04 MPa, 10.4 bar) Maximum Air Working Pressure Part No. 116229 The Used Oil Tank Monitor is designed to provide remote level monitoring of used oil and shut off the air supply to the pump preventing the drum from being overfilled with used oil. When installed with Graco Used Oil Evac Systems, see installation instructions. Instructions – Parts List 309238C Important Safety Instructions. Read all warnings and instructions in this manual and in your pump instruction manual. Save all instructions. Graco Used Oil Evacuation Installation Guide 1/4–NPT x 1/8 NPT Nipple Not Provided IN KIT Installing the Oil Tank Monitor CAUTION The Oil Tank Monitor is not designed to be operated in a caustic environment. NOTE: Although the Oil Tank Monitor is rated for a maximum air working pressure of 150 psi and has a recommended operating pressure of 90 psi, Graco recommends using 50 psi pressure when used with Graco Diaphragm Pumps. WARARNING PRESSURIZED EQUIPMENT HAZARD The equipment stays pressurized until pressure is manually relieved. To reduce the risk of serious injury from pressurized fluid, accidental spray, or splashing fluid, follow the pressure relief procedure whenever you service this equipment. NOTE: If an air regulator is to be used, be sure that it is connected to the air inlet port of the oil level monitor, in this manual, Graco Used Oil Evacuation Installation Guide. 1. Shut down system and relieve system pressure. Follow the Pressure Relief Procedure found in the Pump Module Manual that initially came with your system. 2. Remove thread protector and discard. 3. Connect float chain. 4. Connect air supply to inlet port. 5. Connect pump supply line to outlet port. NOTE: Make sure internal air hoses are connected and there are no kinks. 6. To verify operation turn on main air supply, the pump should start. Lift the float to shut off air supply and pump should stop. TECHNICAL DATA Maximum Air Working Pressure 150 psi -Recommended Air Working Pressure 90 psi -Recommended Air Working Pressure with Graco Pump 50 psi Air Fittings Brass Float Nylon Case and Cover Aluminum Other Parts Aluminum and Steel Posted with eBay Mobile
Condition:
New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...
Model 116229
Brand Graco
MPN 116229

Directions

Similar products from Other Gas & Fluid Monitoring Tools

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies