Ormec Servo Drive SAC-SDM203-SOOOO Rev. 1.0.06, US $50.00 – Picture 0

Ormec Servo Drive SAC-SDM203-SOOOO Rev. 1.0.06, US $50.00 – Picture 1

Ormec Servo Drive Sac-sdm203-soooo Rev. 1.0.06

US $50.00

Cleveland, Ohio, United States
Jan 29th

Open on mobile:
QR code

Ormec Servo Drive SAC-SDM203-SOOOO SD series Servowire Rev. 1.0.06 Main Circuit Power: 115 or 230 VAC +15%, -20%, 50/60 Hz, single phase or three phase Control Circuit Power: 115 or 230 VAC, +15%, -20%, 50/60 Hz, 56 watts RMS, single phase Position Command/Control Loop Update Rates: Digital position command from the host PC via the ServoWire® network. Position loop updated on command at up to 2.66 kHz (application dependent). Velocity loop update rate: up to 5 kHz. Torque loop update rate: 10 kHz ServoWire® Drive I/O: Sensor inputs are software configurable for either NPN or PNP output transistor types and level or edge triggered response. Sensor inputs provide one microsecond response time to capture machine position and initiate motion within one servo loop update. Optically isolated interface for general purpose and motor reference outputs updated every servo loop update with a maximum sink current of 33ma per output. External I/O power supply connections will accept 5-24 VDC (240mA maximum) to power input and output circuits Motor Encoder Feedback Interface: Three differential input channels for encoder position feedback with 5.3 volt encoder power supplied. Quadrature feedback 4x decoding with data rates to 8 MHz (after decode). Open-wire detection on quadrature channels A and B. Support for serial encoders including Yaskawa Sigma II and Tamagawa. Three differential input channels for motor commutation feedback. Input connections for thermal contact from motor windings. Industry standard D-sub connector (25-pin female) interface. Motor Resolver Feedback Interface: Configurable conversion resolution of 12,14, or 16 bits position counts per revolution.Configurable reference signal excitation frequency and transformation ratio. Input connections for thermal contact from motor windings. Industry standard D-sub connector (25-pin male) interface The drive is NOS, surplus. Drive was removed before startup due to design change to installation. No packaging or documentation. Local pickup available Powered by eBay Turbo Lister The free listing tool. List your items fast and easy and manage your active items.

Condition	New other (see details) : A new, unused item with absolutely no signs of wear. The item may be missing the original packaging, or in the original packaging but not sealed. The item may be a factory second or a new, unused item with defects. See the seller’s listing for full details and description of any imperfections.
Seller Notes	“New old stock, surplus removed before startup”