PCB BOARD for Seagate ST2000NM0033 9ZM175-001 SN03 2TB 100706008 REV C +FW, US $69 – Picture 0

PCB BOARD for Seagate ST2000NM0033 9ZM175-001 SN03 2TB 100706008 REV C +FW, US $69 – Picture 1

Pcb Board For Seagate St2000nm0033 9zm175-001 Sn03 2tb 100706008 Rev C +fw

US $69

White Rock, British Columbia, Canada
Jan 29th

Open on mobile:
QR code

This listing is for a PCB (printed circuit board) only If your hard drive meets one of the following situations, you may think it’s board issue 1) there is obvious damage on the PCB board 2) the hard drive does not spin (the hard drive never fell or was shaken) 3) you are very positive the PCB is dead( HDD Clicking often is a mechanical problem) In order to match this board to your hard drive, please match ALL of the following parameters Model ST2000NM0033 Board No. 100706008 Notes This model PCB board has a memory chip which holding the unique Hard Drive configuration info. We need to copy this memory chip info to the new board. We have two options for you: option1: we swap the Memory Chip (EEPROM) for you (free) . If you want us to copy the memory chip, you have to ship your board to us option2: find a local electronic store or a professional electronic technician to help Symptoms of PCB failure: No power. No Spin. No Sound. and wasn't dropped. Hard drive does not spin up. Either no sound or a short, quiet tickling sound can be heard. Burning smell. PCB is extremely hot. See burned mark on the printed circuit board. Power surge. Connect the hard drive case to wrong power supply. Hard drive makes "Clicking sound".(click of death) Symptoms of Seagate firmware brick problem: The hard drive runs fine (no clicking sound or noises, errors etc), but can't be detected by the computer The hard drive runs fine and but the size is 0MBs Symptoms of disk assembly failure: The computer can see the file, but cannot copy the file. The computer can see the hard drive, but the size is wrong The hard drive does not spin but make "beeping sound" failure is because of Falling to the floor, most likely the PCB board is ok, but the disk assembly is damaged. clicking and stop and clicking This PCB is intended for data recovery. This PCB is intended for individuals attempting data recovery on their hard drive. It comes with a fully tested PCB, a torx screwdriver, and a full set of instructions. Please note that is item can fix drives with ONLY a circuit board problem. Some drives have internal damages that can't be detected easily. Please do NOT attempt to open the drive without a clean room. There is no return policy for this item, it is intended for you to diagnose if your hard drive has a circuit board problem, and if it does, recover your valuable data. Please Note The Following: 1. This is just the circuit board of a hard drive, NOT the entire hard drive. 2. There is NO return policy. 3. The board is guaranteed to be tested OK before shipment. 4. It is the buyer's responsibility to determine if the board is adequate for his/her hard drive. 5. We can only provide basic compatibility information for the drive. Shipping Policy Items will be shipped via CANADA POST for regular shipping. Price and shipping times are as follows: Location Cost Delivery Time* United States $0 6-10 business days Canada $0 6-10 business days International free 6-10 business days Italy & Brazil** free 6-20 business days *Please note these are estimated delivery times provided by CANADA POST, and does not include Weekends. **Delivery time to Italy and Brazil is usually between 6-10 business days, however, sometimes it could take up to 20 business days (4 weeks). Overnight shipping is available for the United States. Express is available for all countries, but delivery time will vary, please contact us for more information.