Plastic Acrylic Plexiglass Glue Adhesive #16 1 Pint Weld-on 16 Oz.

US $1700

South Bend, Indiana, United States
Jun 10th

Open on mobile:
QR code

Visit My eBay Store: POP DISPLAYS YOU ARE BUYING A 1PINT of #16 WELD-ON 16 OZ. OUR'S IS (LOW VOC) WHICH IS SAFER TO USE! SUBSTRATE RECOMMENDATIONS WELD-ON 16 is especially formulated to bond acrylic plastic. It can also be used for bonding styrene, butyrate, PVC and polycarbonate, . BONDING RECOMMENDATIONS WELD-ON 16 is recommended as an excellent general purpose, high strength acrylic cement. It is especially useful where fast cure and high strength are desired for applications such as large housings, signs, plastic letters, industrial fabrications, display items, lenses and models. GENERAL DESCRIPTION WELD-ON 16 is a very high strength, clear, medium bodied, fast curing, bodied solvent-type acrylic cement. Applied to cast, molded or extruded acrylics, it will effect initial bonds within minutes and form strong joints within hours.This product may be thinned with WELD-ON 3 by approximately 10%. Initial bond forms very quickly so some parts may be handled within a few minutes of application. Bond strength continues to develop very rapidly reaching a substantial level within hours. Joints are water and weather resistant and will generally have similar physical and chemical properties to acrylic plastic. BOND STRENGTH DATA The following strength data was obtained with compressive shear loading at 0.05”/min.The materials tested were ” acrylic lap joints of 1 sq. in. bonding area. SUBSTRATE MATERIAL 24 HOURS 1 WEEK Acrylic 1700 PSI 2200 PSI Polycarbonate 1000 1700 Styrene 900 1700 ADHESIVE PROPERTIES AND CHARACTERISTICS COLOR: Clear VISCOSITY: 800 cps WORKING TIME: 2 – 3 minutes FIXTURE TIME: 5 – 6 minutes 80% STRENGTH: 16 hours SPECIFIC GRAVITY: 1.02 ± .040 COVERAGE: 10mil: 28sq. ft./Pint 224 sq. ft./Gallon 20mil: 14sq. ft./Pint 112 sq. ft./Gallon DIRECTIONS FOR USE • Parts to be joined should be clean and fit without forcing. • Apply WELD-ON 16 to one or both surfaces with brush, polyethylene squeeze bottle or gun. • If cement is applied to one surface, bring the two surfaces in gentle contact for several seconds to allow the dry surfaces to be softened. • Assemble with firm pressure while parts are still wet. • Hold or clamp assembled parts firmly until initial set. Joint strength will increase greatly in 24 hours. Thereafter, strength will continue to increase gradually for some weeks.