Potter Electric Wireless Repeater For Dry-contact Switch Monitor System 3008030

US $574.99

Kissimmee, Florida, United States
Aug 13th

Open on mobile:
QR code

WR-Repeater The repeater can be powered by one 3.6 volt D size Lithium Thionyl battery or by the auxiliary power of the fire panel or UL 864 or UL 1481 listed 24 VDC supply with battery backup. See ordering information on page 10 for optional power supply. Per UL 864, if the repeater is powered by batteries it must be dedicated to only one transmitter repeater pair. If the repeater is powered by a listed supply it can support multiple transmitters. The device includes a cover tamper, pry-off tamper switch, an LED to indicate when it is transmitting, and an LED to aid in resetting the battery meter. Per NFPA 72, if the repeater is powered by an external power supply, the repeater is allowed to support multiple transmitters and receivers. Although the repeater may support more than one receiver, it can only be paired to one receiver. This selected receiver will display the status of the repeater. If a repeater is powered by a battery, that repeater shall only serve one transmitter/receiver set. This is so that in the event that if the repeater loses its sole source of power, it does not affect more than one transmitter/receiver set. The Wireless Repeater is designed to be mounted to a wall or a post using the optional post mounting kit, see fig. 6. When installing the Repeater outdoors, it may be necessary to install the device so that it is above vehicular traffic. When mounting to a wall make sure the surface is flat enough to activate the pry-off tamper on the back of the unit. When mounting to a post, follow the instructions that come with the post mounting kit to ensure that the pry-off tamper on the back of the Repeater will operate correctly. There is a weatherproof rubber plug in the conduit entrance on the bottom of the Repeater enclosure. When powering the Repeater with batteries, leave the weatherproof plug in place. When using an external power source, remove the plug to connect the conduit. The Repeater can be powered by an on- board battery or an external power supply. It is shipped from the factory in the External Power mode. To switch to battery power, remove the 4 screws holding the cover in place and move the jumper from Com and Ext Power to Batt & Com. See fig. 3. For class A operation, the repeater must be powered by a UL 864 or 1481 listed supply with battery backup. Every repeater must have a backup repeater to provide dual communication paths and each repeater must have it’s own UL864 or 1481 battery backed up power supply so the loss of one power source only affects one repeater. If the system would normally require one repeater, two must be used. If the application would normally require two, four must be used, etc. Please note, only 3 repeaters can be paired to a receiver. If additional repeaters are required for class A operation, the additional repeaters would be paired to subsequent receivers.

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Model	3008030
Custom Bundle	No
Modified Item	No
Brand	Potter Electric Signal
MPN	3008030
Type	Wireless Repeater
Country/Region of Manufacture	United States
UPC	785192027294