Pro 40w Laser Power Supply For Co2 Laser Engraving Machine Ac220v Dc300v

US $76.00

Shenzhen,Guangdong, China
Jan 30th

Open on mobile:
QR code

template 40W Laser power supply for co2 Laser Engraving machine AC220V DC300V Note:This item only support AC220V or DC300V, if you need AC110V or DC150V,pls contact us,otherwise we will send AC220V/DC300V to you! Feature: 1. This power supply use Zero-current half-bridge soft switching circuit,the power supply with high efficiency,fast response characteristics,it is easy to fit a variety of manufacturers of laser tube 2. Port control is simple to adapt to high and low two kinds of signals can be controlled using TTL level laser start,stop,while adding an exception to product the switch to detect whether an external water,ventilation,etc. 3. Laser power adjustment either 0 to 5V input analog signal can also be input PWM signal to control the size of the laser power 4. Power supply has open circuit protection:In case of good protection earthing,power can work in the short open state,so to avoid damage due to bursting of laser tube laser power 5. Factory aging test:Each power supply will go through a high temperature of 60 degrees under full load burn-in test status 12 hours,7 seconds to open the power to stop the test 500 times Parameter: AC input voltage AC220V DC input voltage DC300V AC input frequency 47~440Hz Output voltage 30KV Maximum current 20mA Efficiency 91% Over-current protection =3V Low-level control voltage range