Radiant Heat Control Panel- 2 Zones/ 2 Temp (keywords; Boiler, Pex, Floor Heat)

US $3,499.00

Olathe, Kansas, United States
Jun 9th

Open on mobile:
QR code

Take the Mystery out of the Mechanical Room Our radiant heat panels are the perfect solution for any project: floor warming, heating, or snow melt. Pre-piped, pre-wired, and shop tested by trained professionals. These panels will dramatically reduce installation time as well as virtually eliminate wiring and other start-up problems. The only wiring required is to connect the zone thermostats to the corresponding relay terminal. Each mechanical package is pre-wired with a 120 volt power cord. Best of all, each of our hydronic panels are designed for easy system maintenance. Each component on the panel can be easily accessed and isolated with numerous shut-off valves located on all panels. So, don’t let your next radiant project slow you down. Our hydronic panels are fast, easy, and guaranteed to take the mystery out of the mechanical room. < border="0"> This Radiant Panel’s Specifications; Boiler: The boiler is not included in this listing. The panel can/will be custom built to plumb to the boiler you intend to use. Electronic Zone Controller: Controls 2 zones with installed power cord for plug in installation to your existing 120 VAC outlet. A service on/off switch is provided. One air sensing thermostats are provided and the controller is wired to service these thermostats. Slab temperature sensing thermostats are available. No on-site electrical wiring is necessary. Mixing Valve: TACO- TWO TEMPERATURE SYSTEMS ARE REQUIRED WHEN DIFFERENT HEAT EMITTERS REQUIRE TWO DIFFERENT FLUID TEMPERATURES. Examples of this would be both concrete in-slab and baseboard heaters being used in the same installation. Baseboard typically requires 160-180 degree fluid. Concrete in-slab typically requires 105-125 degree fluid. Circulation Pumps: Three TACO circulation pumps installed with service shut-off valves on both sides. Microbubble Air Remover: TACO Zone Ports: Unless otherwise requested each zone port(s) is equipped with 3/4" PEX crimp fittings for a quick no solder connection. Zone port(s) are equipped with shut-off valves. Ports will be installed in whatever configuration makes your installation easier for you, i.e. up or down. Other Features: Auto Fill Port with Backflow Preventer, Custom Sized Expansion Tank Included, Pressure reducing valve, Temperature/ Pressure Gauge on Boiler Out Side, Manual Glycol Fill Ports, System Drain Valve for Connection to Water Hose. The biggest cost of any Hot Water Radiant Heat System is the labor to build and install. Due to the special requirements of Radiant Heating Systems local plumbers and heating companies are often not familiar with the specifics of system builds. We take the guesswork out of system builds utilizing our skilled Engineers and system builders. You know what your costs are going to be upfront. We custom design each and every radiant heat boiler panel system to your specific system requirements. If this particular unit does not meet your needs we can custom build a panel specifically to your requirements. Curry Heating Systems in an International award winning, custom design and build, hot water heating Company. Each heating system we build is custom to the owner, building and climate it is to operate in. If you have any questions on this or any of our products please do not hesitate to contact us. SHIPPING IS FREE TO THE LOWER 48 US STATES. ADDITIONAL COSTS FOR SHIPMENT TO ALASKA. SHIPPING TO CANADA IS AVAILABLE. CANADIAN CUSTOMERS PLEASE CONTACT US FOR A FREIGHT QUOTE. CANADIAN CUSTOMERS ARE RESPONSIBLE FOR ALL BROKERAGE, IMPORT FEES AND TAXES.