Repeater Controller Ics Linker Iia

US $65.00

Loganville, Georgia, United States
Jan 29th

Open on mobile:
QR code

ICS LINKER IIa REPEATER CONTROLLER Programming Very easy to set up and operate Uses the ICS operating system Values entered in volts, seconds, WPM (Even Fractional Values) Uses More, Good, Bad, indications when programming in values and parameters All programmable data stored in onboard EEPROM Over 130 functions available (and more to come...) Has excellent support for X banding - Interoperability - One service can talk to another Programmable courtesy tones Separate, full control receiver input, separate COS and audio inputs DTMF Control System DTMF for programming and control DTMF control using Port 2 if enabled 25 DTMF programmable code / function memories Each DTMF code can be programmed to be from 1 to 5 digits Has DTMF muting on both ports (can be disabled) In programming mode all functions can be entered in directly using their 2 or 3 digit number Setup mode (programming mode) Control op mode and User mode Electronic Control System High quality JFET opamps - Top audio quality, High output High quality JFET transistors used in the audio circuit Low rolloff <50Hz Programmable timer for TX fan control Programmable courtesy tones Microprocessor control of encode and decode Beacon mode Programmable Antikerchunker filter Discriminator or straight through audio for all 3 receiver ports By adding a resistor audio can go from the control RX to the repeater TX Seven high quality pots (Bourns) for level adjustments Nine LED's for system status indication Built in Watchdog timer The Linker IIa has 3 auxiliary outputs (one or two are shared with port 2) CTCSS and COS Full control receiver port, COS, audio and has priority Separate Plug for a third party encode / decode module (TS 64) COS only, CTCSS only, AND, OR functions available on ports 1 and 2 Encode is mixed in with the transmitter's audio if enabled Voltage and polarity selectable COS input for the control receiver Voltage and polarity programmable COS and CTCSS inputs for both port 1 and 2 Special dedicated 10 pin plug for port 1 CTCSS A programmable encode hang timer can be enabled / disabled Antikerchunker filters on Port 1 and Port 2 Port 1 and Port 2 activate TX1 encode, if enabled, port selectable Remote Base / Link functions (Port 2) Port 2 can be setup as half duplex, full duplex, slave repeater and xpeat Remote base memories are controlled by the Linker IIa controller Remote base memory number read back after the memory is selected and by request Selection of a remote base memory is done just by selecting the memory number The remote base control system remembers the current remote base memory The Linker IIa will return the remote base to the home memory when disabled Other information Over 85 Page Manual with Schematic Same Item still sells for $139.95 on ics-ctrl dot com Small footprint of 4" x 4.5" Full ground plane on board for quiet audio and RFI protection Sold AS-IS