Rotate Pick Magnetic Speed Sensor Generator Parts Up Msp677

US $32.35

  • Shanghai, China
  • Jan 30th
MAGNETIC PICK UP MSP677 ROTATE SPEED SENSOR GENERATOR PARTS TWO DIRECTION 1PC AUTOMATIC LABEL REWINDER AL-938 REWINDING MACHINE BRAND NEW DUROMETER RUBBER HARDNESS TESTER MEASURE BRAND NEW SHORE TYPE A GAUGE 1PC RAY RECOGNIZING OPTICAL FIBER IDENTIFIER NEW FIBER OPTIC 800-1700NM RY-3306ID 1PC M-1000 AUTOMATIC 220V 7-50MM WIDTH MACHINE 20-999MM LENGTH TAPE DISPENSER   Specifications: Item: MSP677. speed sensor. generator sensors. Drill Size: 37/64. Thread Length: 2.75". Rotate speed sensor. Pickup Length: 3.125". Overall Length: 4.25". Thread Size: 5/8-18 UNF-2A.   Introduction: The magnetic speed sensor indicates when ring gear teeth, or other ferrous projections, pass the tip of the sensor. Electrical impulses are induced within the coil and sent to the speed control unit. The signal from the magnetic speed Sensor, teeth per second(HZ), is directly proportional to engine speed.   Description: The magnetic speed sensor is mounted in the ring gear case or flywheel bell housing of the engine. The threaded hole for the speed sensor should be perpendicular to the centerline of the crankshaft and centered over the ring gear teeth. A spot face should be present to provide a flat surface on which to anchor the locknut. With the engine stopped, screw the speed senor in until it touches a gear tooth, then back it out 3/4 of a turn and secure it with the locknut. Any ferrous gear may be used as long as the frequency and amplitude of the resulting signal meet the speed control unit specifications. The wire leads should be twisted for their entire length from the magnetic speed sensor to the control unit. The leads may need shielding if they are longer than 10 ft. (3m), or if external interference is present. Do not connect either of the speed sensor leads to anything but the speed control unit used. The shield should not be connected at the speed sensor end. awor uwhu kbwl UAC Buyer should pay within 7 days after purchase. We only accept payment via PayPal. Our team focuses on providing high quality products with reasonable price and tries its best to keep transactions as simple as possible. Please be confident of and enjoy your shopping here! Please feel free to contact us via eBay message system or email.

Directions

Similar products from Generator Parts & Accessories

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies