Rotocon Lab Frame, Naz33, 1/2" Aluminum 6061-t6 Rods

US $210

  • Chattahoochee, Florida, United States
  • Jun 5th
 ROTOCON LAB FRAME, Model NAZ33, 3 Ft Wide by 3 Ft High and approximately 18 Inches Deep. This model exhibits the "No Base Support Rod" design. Made of 1/2 inch round 6061-T6 solid Aluminum rods connected and anchored by our tough Rotocon Zinc-alloy Assembly Clamps using nickel-plated steel nuts and screws. Sturdy construction with rod support, horizontally and vertically, at 12 inch intervals will accomodate medium to heavier loads providing a very strong lattice support. There are four anchoring bases which can be attached to your table top, hood base, plywood base or floor to prevent tipping over. These clamps can connect at 10 degree intervals and will allow much versatility in design and construction. Detailed suggested assembly instructions for frames as pictured are included. The kit contents are as follows: 10 each 1/2 inch round aluminum solid rods 36 inches in length, 20 sets SRT-1/2 Zinc-alloy Snap-On Assembly Clamps, 2 sets M-90 Zinc-alloy Mounting Base and 8 stainless steel screws for anchoring.  Assembly required. Tape measure, Phillips and flat blade screwdriver are needed but not included in package. (This design also comes in various sizes and strengths, with connectors made of Lexan, Zinc-alloy or Aluminum-alloy, anchors made of Lexan, Zinc-alloy or Aluminum-alloy, and rods made of 1/2" round tubular stainless steel, solid stainless steel, solid aluminum or white fiberglass rods). These other models can be found on our website, rotocon dot com.

Directions

Similar products from Clips, Holders & Frames

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies