Scmi Selecta 20 F Edgebander Edge Bander

US $9800

Danville, Vermont, United States
Nov 8th

Open on mobile:
QR code

SCMI Selecta 20 F Edge banding machine. Was working when removed from service a couple of years ago and had been stored inside, dry since then. I do not know the current working order of this unit and cannot test. This is being sold as is. I will not guess or assume working order although it does appear generally complete. This unit weighs roughly 5000 lbs and I can load onto your flat bed trailer but cannot load into a box trailer. Please feel free to call with questions 802-249-2763 .4-20 mm Cap. edgebanding thickness and 3/8" - 2-1/4" height; min panel length 5-1/2" and min. width 2-3/8". Automatic strip & coil feed magazine with 3 mm PVC guillotine. Equipped with: 4.4 Lbs Capacity "fast heat-up" granular glue system, Teflon coated lower applicator glue pot, 1" dia. glue applicator roller. Pressure section with: (1) Large dia. clutch controlled drive roller and (4) pneumatic pressure idle rollers, independent adjustment of drive & idle rollers w/digital indicator. Workstations: Front and rear end trims (0.75 HP - 12,000 RPM motor ea.), motors tilt 0° - 15° on horiz. plane. 1st Top & bottom flush/bevel trims (2.5 HP - 12,000 RPM motor ea.), motors bevel from 0° - 45°, digital readout for easy setup. 2nd Top & bottom flush/bevel trims (1 HP - 12,000 RPM motor ea.), motors bevel from 0° - 45°. Top & bottom PVC scrapers, pneumatic pressure control for scraping knives, digital readouts. Top & bottom buffing (0.4 HP - 1,680 RPM motor ea.), units tilt 0° - 30°. Post heating with hot air blowers Feed chain with white rubber pads, single feed speed of 33/60 FPM, 2 HP feed drive. - Complete with: Insulated sound enclosure w/large window area. SOLD AS-ISa