Shell And Tube Heat Exchanger Made In Japan

US $200.00

  • Jacksonville, Florida, United States
  • Jan 29th
These units came off of a plastic injection molding machine made in Japan I cannot read the label and I lost the only label that I could read while trying to clean it. the end cap says KAMUI. They are 2 pass units and oil ran on the shell side and water on the tube side. There is a little rust in the tubes but it is surface rust that can be cleaned. I purchased 8 of these but only used 4 of them and had no problems with the 4 that I used.  18 tubes 9 per pass and the diameter is 10mm or .400 thousands. The end caps are "O" ringed. The inlets and outlets are 3/4 standard pipe thread. The model # is LCA 310 P15. I have 2 of these. The price is for 1. If you have any questions you can send me a message or you can call me at 904-334-5761 Jeff. Thank you for helping me cleaning out my warehouse. 
Condition Used :
An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. This item may be a floor model or store return that has been used. See the seller’s listing for full details and description of any imperfections.
Seller Notes normal wear and tear

Directions

Similar products from Heat Exchanging Systems

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies