Sparkfun Thing Plus Nrf9160 Microcontroller

US $149.44

Swanton, Vermont, United States
Jul 16th

Open on mobile:
QR code

Description SparkFun Thing Plus nRF9160 Microcontroller Features the powerful Nordic nRF9160 microcontroller Designed to work with Zephyr Feather-compatible footprint Capable of both CAT M1 LTE and NB-IoT cellular communication Doesn't require soldering The SparkFun Thing Plus nRF9160 Microcontroller featuring the powerful Nordic nRF9160 microcontroller in a Feather-compatible footprint. Not only can you take advantage of Nordic’s advanced power states, but you can also put the device into a low-power standby state. This little chip is capable of both CAT M1 LTE and NB-IoT cellular communication and is designed to work with Zephyr, the go-to RTOS for embedded development. To make the Thing Plus even easier to use, this board utilizes the handy Qwiic Connect System which means no soldering or shields are required to connect it to the rest of your system. Laboratory measurements are putting that mode at about 2µA of current. 2µA! It also features a 3.3 V Buck-Boost which helps get every mWh from your batteries as possible. Specifications USB-C connection for USB-to-Serial and DFU Pre-programmed MCUBoot bootloader Low Power RTC onboard for timekeeping and as a low power wakeup source. Transceiver and baseband 3GPP LTE release 13 Category M1 and NB1 compliant 3GPP release 14 NB2 compliant GPS receiver (GPS L1 C/A supported) - Active antenna only. Supports 4FF Nano SIM RF Transceiver for global coverage supporting bands Cat-M1: B1, B2, B3, B4, B5, B8, B12, B13, B14, B17, B18, B19, B20, B25, B26, B28, B66 Cat-NB1/NB2: B1, B2, B3, B4, B5, B8, B12, B13, B17, B18, B20, B25, B26, B28, B66 Nordic nRF9160 Microcontroller with ARM Cortex M33 1 MB Flash 256 kB RAM ARM TrustZone ARM Cryptocell 310 Up to 4x SPI, I2C, and UART with Easy DMA I2S w/ EasyDMA 4x PWM with EasyDMA 12bit SADC with EasyDMA 2x RTC PPI (Programmable peripheral interconnect) interface Radio External NOR Flash by Winbond 4 MB of space Max bus speed of 133 MHz Standard SPI Power supply 3.3 V Buck/Boost up to 0.9 A of current draw Operating range 2.8 to 5.5 V External LiPoly battery connection (JST SPH type) Charge rate set to 300 mA with LED indication Programmer Capable of interfacing with J-Link and CMSIS-DAP based programmers User I/O Standard feather form factor GPIOs (0.1 inch pitch) 2x buttons (1 Reset, 1 General Purpose) 1x Blue LED connected to D7 Antenna connections 1 x U.FL for LTE with matching network 1 x U.FL for active GPS antennas What's Included 1 x SparkFun Thing Plus - nRF9160 1 x Hologram SIM Card Dimensions Size 58.42 x 22.86 mm / 2.3 x 0.9 inch (L x W) Board: 2.10 x 0.70 inch (L x W) Multimedia

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Brand	Sparkfun Electronics
Type	Sparkfun Electronics
MPN	WRL-17354
UPC	Does not apply