T92s7d22-22 - Carrier Replacement Furnace Relay By Carrier

US $15.95

Cleveland, Ohio, United States
Aug 21st

Open on mobile:
QR code

You are bidding on a BRAND NEW Carrier Replacement Furnace Relay by Carrier. It is p.n. T92S7D22-22. It is bulk pack so there is no box but the part number is right in the plastic housing. It is MINT and has no scratches, marks, nicks or stains LAST ONE!! Features, Applications 30A, 2 form A (NO) and 2 form C (CO) switching capability Designed to control compressor loads to 3.5 tons, 25.3FLA n Meets requirements UL 508 and UL 873 spacings - 8mm through air, 9.5mm over surface n Meets requirements of VDE 8mm spacing, 4kV dielectric coil-tocontact n Meets requirements of UL Class F construction n UL approved for 600VAC switching (1.5HP) n New screw terminal version (consult factory for availability, ratings) Typical applications HVAC, residential / commercial appliances, industrial controls Approvals Contact ratings 1) (continued) ARI 780-86 Endurance Test (section 6.6): HVAC Definite Purpose Contactor Standard Normally Open Contacts Single Phase/Two Pole (Both poles together switching a single load) 110 LRA, 25.3 FLA, 200K operations (DC Coil) Contact arrangement 2 form A (NO), 2 form C (CO) Rated voltage 277VAC Max. switching voltage 600VAC Rated current 30A NO; 3A NC Limiting continuous current 30A NO; 3A NC Limiting making current 30A NO; 3A NC Limiting breaking current 30A NO; 3A NC Contact material AgSnOInO, AgCdO Min. recommended contact load 500ma (NO)/ 100ma (NC), 12VAC Frequency of operation, with load 360hr Operate/release time max., including bounce 15/15ms Contact ratings 1) TypeLoad UL508 AgCdO 40A, 277VAC, resistive 30A, 120/277VAC, resistive 10A, 600VAC, general purpose 110LRA/25.3FLA, 240VAC (DC coil only) 60LRA/14FLA, 240VAC (AC coil only) 3A, 240VAC, pilot duty 20A, 28VDC, resistive 1A, 600VAC AgSnOInO 30A, 120/277VAC, resistive (DC coil only) 30A, 120/277VAC, resistive (AC coil only) 20A, 480VAC, resistive 120VAC, 2 pole making/breaking 240VAC, 3 phase (DC coil only) 480VAC, 3 phase (DC coil only) 600VAC, 3 phase (DC coil only) VDE AgCdO, flange mount relays / 3A NC, 400VAC AgCdO, PC mount relays / 3A NC, 400VAC 03-2012, Rev. 0312 [link removed by eBay] © 2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company Single Phase Per Pole (Single load per pole) 110 LRA, 18 FLA, 200K operations (DC Coil). 60 LRA, 14 FLA, 200K operations (AC Coil). 1) Contact ratings at 25°C (unless otherwise noted) with relay properly vented. FLA, LRA ratings are compatible with 3.5 ton compressor applications. All figures are given for coil without preenergization, at ambient temperature +23°C. Datasheets and product specification according to IEC 61810-1 and to be used only together with the `Definitions' section. Datasheets and product data is subject to the terms of the disclaimer and all chapters of the `Definitions' section, available at [link removed by eBay] Datasheets, product data, `Definitions' section, application notes and all specifications are subject to change. T92 Series Two-pole 30A PCB or Panel Mount Relay (Continued) Ambient temperature vs. coil voltage Assumptions: 1. Thermal resistance = 35°C per Watt (DC only.) 2. Still air. 3. Nominal coil resistance. 4. Max. mean coil temperature = 155°C (change of resistance method). 5. Coil temperature rise due to load @ 30 amps. 6. Curves are based at 25°C (DC only.). Material compliance: EU RoHS/ELV, China RoHS, REACH, Halogen content refer to the Product Compliance Support Center at [link removed by eBay] Ambient temperature DC coil 85C AC coil to 65C Category of environmental protection IEC 61810 RTI - dust protected, RTII - flux proof, RTIII - wash tight Vibration resistance (functional) 1.65mm max excursions, 10-55 Hz Shock resistance (functional) 10g for 11msec Shock resistance (destructive) 100g Terminal type pcb-tht or quick connect Weight86g Resistance to soldering heat THT IEC 60068-2-20 250°C Packaging/unit tray/30 pcs., box/120 pcs. Initial dielectric strength between open contacts 1500Vrms between contact and coil 4000Vrms between adjacent contact 2000Vrms Initial surge withstand voltage between contact and coil 6kV Initial insulation resistance between insulated elements 1x109 Clearance/creepage between contact and coil 8mm clearance/9.5mm creepage Dimensions T92 Mounting and termination code T92 Mounting and termination code 2, 3 and 4 Terminal assignment Bottom view on pins 2 Form A 2 Form C PCB layout Bottom view on pins T92 - Mounting and termination code 1 An alternate PC board layout (1.93 ±.076) diameter holes on the same center-to-center spacing shown above. Use of the rectangular holes is recommended for improved solderability. Only necessary terminals are present on single throw models. Consequently, some holes will be unnecessary for single throw models. Type T92 Printed circuit board / panel mount power relay T92 Enclosure P Dust protected plastic case S Wash-tight, tape sealed, plastic case (Mounting and termination code 1) Top sealed, not wash-tight, not tape sealed on bottom (Mounting and termination codes Contact arrangement 7 2 form A (2 NO) 11 2 form C (2 CO) Coil Input A AC voltage, 50/60 Hz (consult coil versions table) D DC voltage Mounting and termination 1 Printed circuit board mount; printed circuit board terminals. 2 Panel mount via flanged (.81mm) QC terminal 3 Panel mount via flanged (.81mm) QC terminals for coil and.250" (6.35mm) for contacts 4 Panel mount via flanged (.51mm) QC terminals for coil and.250" (6.35mm) for contacts. 5 Panel mount via flanged cover, M4 screws w/ captive pressure plates. Requires Enclosure P and Contact arrangement 7. Contact material 2 AgCdO 4 AgSnOInO Coil voltage Coil code: please refer to coil versions table This is a Quality Breaker for a CHEAP PRICE!! MY PRICE IS DIRT CHEAP!!! FREE SHIPPING 144 / 6149 Please take a look at the pictures to get a better idea of what you are bidding on. If you have any questions, please email me. THIS IS A STEAL OF A DEAL AT THIS PRICE!!! TAKE A LOOK AT OUR AMAZING DEALS! I ship same or next day upon receipt of payment. Pay Pal sales are shipped within 1-2 business days. High bidder pays $8.00 for shipping and insurance (Continental USA ). If you have any questions, please ask them before you make your bid. Also please view all of the photos and if there is a discrepancy between the description and the photos, the photos are the overriding factor (i.e. description may say good condition but photo may show a chip or flaw). Images directly above are of the actual item. What you see is what you will receive. YOU WILL NOT GET WHAT YOU DON'T SEE We take all our own pics. unless noted. 100% Customer Satisfaction We are committed to making you 100% satisfied. If you have any problems with your order, we will do whatever we can to resolve it immediately. We strive for all 5s in our detailed seller ratings. If there is any reason you don't feel we should have 5 stars, Please contact us before you leave feedback. FEEDBACK POLICY Buyer must agree to contact Unreal Deal before leaving any negative feedback or filing a dispute so that we may try to resolve the issue privately. Negative feedback affects both Buyer and Seller whether the issue is a misunderstanding or an actual problem. I would love you to leave a positive feedback since I am new to ebay:) OUR SHIPPING & HANDLING POLICY We ship most packages USPS When Shipping with UPS we need to ship to a Physical Address NOT a P O Box. All shipping fees are for the lower 48 states. For us to ship to APOs & FPO's - Hawaii, Puerto Rico- Alaska -we will need to ship parcel post or priority mail THIS TAKES LONGER SO BE PATIENT BECAUSE ITS CHEAPER THAN UPS Return Policy We will ONLY accept return of the goods up for auction only if they are not as described in this listing. You will be responsible for all return shipping. You must also contact us within 3 days of receiving the item or a refund will not be granted. The goods will be inspected upon return and a refund will sent after we inspect the item. NO Refunds for undamaged items or you changed your mind after the purchase. ALL PAYMENTS ARE EXPECTED IN 4 DAYS OR LESS or we will file non paying bidder alerts. If the item is not paid for in 7 days from the end of the auction we will offer it to others or relist the item. Please email us with questions prior to purchases. We will do our best to answer your questions. Listing and template services provided by inkFrog

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Brand	Carrier Replacement
Country/Region of Manufacture	United States
MPN	Does Not Apply