3 inch hydraulic cylinder for sale, brand-new and used.

Preowned hydraulic cylinder. There is not a brand label on it anymore. Color green.

Preowned, cross hydraulic cylinder. 2 1/2 x 8". It Held pressure when I took it off of the assymbly.

Preowned, five point hydraulic cylinder. 2 1/2 x 8". 2500psi.

For sale is one Enerpac RC-210 50 Ton hydraulic cylinder with max working pressure of 10,000 psi. It has a 3.5 inch diameter cylinder with a stoke of 5 3/4 inches (** measured stroke is ~5 3/4 inch however makings on cylinder wall indicate up to 6") The cylinder is missing the hardened saddle that sits on top of the cylinder and the paint has seen some wear and tear however the sides of the piston are rust and damage free as is the base.

~~UP FOR SALE~~ PARKER # 2.50 CC3LCT 14AC 72.000 CYLINDER1400PSI HYD3 AVAILABLE77" IN LENGTH2.5 WIDTH/HEIGHT THESE WERE PURCHASED AT A CASTING FOUNDRY, FROM THEIR OBSOLETE PARTS INVENTORY. THESE MAY BE NEW OR REFURBLISHED. BUT WERE IN STOCK AS REPLACEMENTSSO THEY WERE READY TO USE, 3L series tie rod hydraulic cylinders are heavy duty, inch-dimensioned cylinders rated for use at working pressures up to 70 bar depending on the rod end and type of service.

Prince Manufacturing Prince B350100ABAAA07B Double-Acting Tie-Rod Hydraulic Cylinder, Clevis Mounting, Painted, 3-1/2" Bore, 10" Stroke, 1-3/8" Rod Diameter, 3/4"-16 Thread, #8 SAE Port

[ Maxim 218-319 2-1/2 In Bore Dia 10 In Stroke 2500 PSI Hydraulic Cylinder

Enerpac SCR-102H Single Acting Cylinder Pump Set RC-102 Cylinder with P-392 Hand Pump

Enerpac SCL-101H Single Acting Cylinder Pump Set RCS-101 Cylinder with P-392 Hand Pump

This is a small hydraulic cylinder. I am not sure what is was made to do. It has one inlet and appears to be made to be welded in place by the angle bracket.

[ Maxim 288-362 3-1/2 In Bore Dia 48 In Stroke 3000 PSI Hydraulic Cylinder

This Hydraulic Cylinder Jack has been on the shelf in an outbuilding for many years and I don't know if it's new or re manufactured, It has a 1/4" pipe NPT hole in both ends, still the original plugs in them, It's made by Ortman Miller Mach Co. Inc. Hammond Ind.

NEW CHIEF HYDRAULIC CYLINDER. PART NUMBER 207-428 IT IS;3 INCH BORE4 INCH STROKE1-1/2 ROD12 INCH RETRACTED16 INCH EXTENDEDSAE8 PORT SIZE1 INCH PIN HOLES3.500 OUTSIDE DIAMETER0.187 THICK WALLS