2022UD6G.3.36 New Sanyo Denki, Ball Bearing, 1.1 Amp, 1.8 Degree Step (200 Steps per Revolution), Stepper / Stepping Motors, Part Number 103-775-7241. Each bid quantity is for a Lot of Four (4) Motors. You may bid / buy any number of lots, up to the total quantity available above.
Used motor pulley from a Delta Rockwell Unisaw. 5 1/2" diameter for the 1725 RPM motor, 3/4" bore.Good condition, see pics for more details.Includes just what is in the pics. I will combine shipping.
Used motor pulley from a Delta Rockwell Unisaw. 3 9/16" diameter 3/4" bore.Good condition, see pics for more details.Includes just what is in the pics. I will combine shipping.
Pulley and Table Clamp Set; from Sargent Welch Item #CP77700-00; Table Clamp can hold the pulley rod in either of two positions and in each, the rod may be rotated both about its axis and a full 360° in a plane perpendicular to the table top. The clamp fits tables up to 5.6cm thick. The molded styrene 3.8cm sheave runs in adjustable cone bearings at the end of a 12cm long rod.
I HAVE PROVIDED PICTURES AND WILL GLADLY ANSWER ANY QUESTIONS. THIS WAS PURCAHSED NEW FOR A SINGLE PROJECT AND WAS NEVER ACTUALLY USED AND WAS STORED IN THE PROJECT TOOL TRAILER. THE KIT IS COMPLETE, EVERYTHING WORKS AND I HAVE PROVIDED THE INFORMATION BELOW.
These pulleys are from a nearby printer that went out of business and forgot to give these to the buyer of his two verticals. This is a 3-3/16" outer diameter, 1-1/16" spline size (the spline is the locking shaft the pulley slides on to) speed pulley for a Miehle V-50 Vertical. As it was originally 3-1/4", it is obviously very used.
These pulleys are from a nearby printer that went out of business and forgot to give these to the buyer of his two verticals. This are two 3-9/16" outer diameter, 1 7/8" spline size (the spline is the locking shaft the pulley slides on to) speed pulleys for a Miehle V-50 Vertical. YOU ARE ONLY BIDDING ON ONE PULLEY AT A TIME.
These pulleys are from a nearby printer that went out of business and forgot to give these to the buyer of his two verticals. This is a 4-1/16" outer diameter, 1-7/8" spline size (the spline is the locking shaft the pulley slides on to) speed pulley for a Miehle V-50 Vertical. As it was originally 4-1/8", it is obviously very used.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.