4-40 stud for sale, brand-new and used.

Command CAT 40 Tool Holder C4E4-1250 for 1-1/4" shank w/pull stud. Number at end of title is inventory number. Powered by eBay Turbo Lister The free listing tool.

Command CAT 40 Tool Holder C4E4-1250 for 1-1/4" shank w/pull stud. Includes installed Collis quick change 1/2 x 1-1/4 holder. Number at end of title is inventory number.

Command CAT 40 Tool Holder C4E4-0750 for 3/4" shank w/pull stud, end damaged, see photo. Shank hole not affected. Number at end of title is inventory number.

NEW Dayton 3LU84J Direct Drive Blower Motor 1/2 HP 1075 Nameplate RPM 208-230V

DECKEL 40 TAPER COLLET LOT.  Good usable condition. 20mm buttress thread stud. Lot has sizes.

echnical Specs Item Direct Drive Blower Motor Motor Application HVAC/R Motor Sub Application Direct Dr Fan/Blower Motor Design Permanent Split Capacitor Motor Enclosure Design Open Air-Over HP 1/3 Nameplate RPM 1075 Voltage 208-230 Full Load Amps 2.6 Hz 60 Phase 1 Frame 48Y Motor Service Factor 1.00 Max. Ambient Temp.

Highlights: Dimensions: 7.1" x 3.0" x 1.2" (180 x 75 x 30mm) Big, bright backlit LCD Visual and audible indications Marking slot on top of unit Center arrow and beeper pinpoint edges Automatically compensates for wall thickness in all three detection modes In AC voltage mode, automatically compensates for dis

Hard-to-Find Fastener 014973237035 Concrete Stud Anchors, 1/4-Inch x 3-Inch, 8-Piece

Greenlee 229 Electronic Connector Panel Punch, 9 Pin

UP FOR SALE HVAC MOTOR , HERE ARE THE SPECS : Motor Application HVAC/R Motor Sub Application Direct Dr Fan/Blower Motor Design Shaded Pole Motor Enclosure Design Totally Enclosed Air-Over Duty Continuous HP 1/70 Nameplate RPM 1550

Dayton HVAC Motor Mfr. Number: 4M193Motor Design: Shaded PoleMotor Enclosure Design:

Dayton HVAC Motor Mfr. Number: 3M728Motor Design: Shaded Pole

Greenlee Communications 735BB Round Manual Knockout Punch Kit features 1/2"-1 1/4" conduit sizes with .89"-1.70" (22mm-43mm) hole sizes. Durable design has a capacity of 10-gauge (3.5mm) mild steel but also cuts aluminum, fiberglass & plastic. Use these punches with battery-powered hydraulic, ratchet or manual driver.

Western Electric Pulse Meter, 4 1/2 Inch Face NSN: 6625-00-881-4613 P/N: C9A Western Electric Pulse Meter, 4 1/2 Inch Face FS-200UA This is a surplus meter that has never been used and is in excellent condition. If any questions, feel free to email me.

Nut & Bolt Thread Checker (SAE/Inch)