4 surface bolt for sale, brand-new and used.

UJ Robichaud TIM-BR Mart

UJ Robichaud TIM-BR Mart

UJ Robichaud TIM-BR Mart

Vintage antique Green Instrument Company , Name Plate Edger No. / Number 500 . It works but has wear or surface rust .

The Stickler best log splitter on market quick and easy to use Father purchased two some years ago, Never worn out first one yet, moving and no need to split wood any more The Stickler and mount PL7 adaptor included (one stud missing, needed for other one) can be purchased yet PL7 adaptor mount has a 4 3/4" 5 hole bolt patten Other adaptors can be purchased threw Stickler site Stickler was stored in garage for some years and paint on bottom fl

When you want one of the best impact wrenches made, then you are looking at the Ingersoll Rand 3940B2Ti 1" square drive air impact wrench delivering 2500 FT LB of maximum torque. These impact wrenches are Made in the USA with with the highest quality materials in the world, including a titanium hammer case. These units were built to last for many years of service!

1 5/16" Heavy Duty Track Bolt Socket made by Caterpillar. The name Caterpillar is not found on the socket, but the part number is consistent with the Cat part number. Uses a 1" drive ratchet.

MAXSALES 2-PC BULL PIN SET 10" & 13" KLEIN TOOLS USA Features: Broad head for a larger striking surface and increased efficiency.

Up For Auction is a Vintage 1/4" R Die Pipe Bolt Threaders NPT Machinist Tool. Used but in good condition. Does have surface oxidation.

Up For Auction is a Vintage Reed 3/4" R Die Pipe Bolt Threaders NPT Machinist Tool. Used but in good condition. Does have surface oxidation.

This is a cast iron bolt on style flat belt pulley. Unknown manufacturer & is unmarked. The width of the flat face is 8 & 5/16th.

Here is a vintage muffler that may have been from a snowmobile, tractor, gas engine or antique vehicle. This 9" long x 5" round muffler body has a 1-1/2" inlet flange with two 3/8" bolt holes, one slotted, about 2-11/16" apart mounted at about a 30 degree angle to the main body and a curved 1-1/2" outlet that is about 5" long. There is a 1/4" mounting stud on one end and a hoop approximately half way on the opposite side.

Here is a hot IHC brass magneto up for auction. It has been cleaned and magnets flashed and a new repro band added this past summer then shelved. Little wear showing on the base threads but usual and expected; trivial in my books.

Here is a thermostat housing that bolts to the head of a model OY91 4 cyl. flat head Continental gas engine. This collectible gas engine tractor / equipment part has the numbers 400K321 along with the letters SF in raised cast lettering on the 5" long x 1-1/2" O.D.