This is a brand-new Timing Belt Pulley XL 10 Tooth 6.35mm or 1/4" Aluminum Bore for 3D printer This Timing Belt Pulley XL 10 Tooth 6.35mm or 1/4" Aluminum Bore for 3D printer is used on the DNP linear motion sliders. It attaches to the DNP Cameras in Motion Pulley assembly. It is a 10 tooth pulley With a 6.35 mm (1.4") Bore which excepts a timing belt that is 3/8 inch wide with a 1/5 pitch pitch.
FLEXCO Alligator Staple System, Belt Fastener, Conveyor Belt Lacing RS187J36/900NC 4 Sets of RS187 Joints for 36" Belts With pre-inserted staples and a one-piece strip design, Alligator® Ready Set™ makes splicing quick and easy.
5 Aluminum Stepper/Servo Timing Belt Pulley w/Hub, 30T, .250" Bore, 0.816" Pitch These were removed from a stepper motor drive assembly used on a video editing machine, and are in good condition. "30LT" is stamped on the side of the pulley as can be seen (with some effort) in the photo. Material - Aluminum Alloy Teeth - 30 Flanges - 2 w/hub Bore - .250" Pitch - .0816 (40 D.P.
2010UD6G.13.40 New Sanyo Denki, Ball Bearing, 2 Phase, 42MM Sq. (1.65 inch sq.), 5.3 OHM, 1.8 Degree Step (200 Steps per Revolution), Stepper / Stepping Motors, Part Number 103H5208-10U41. Each bid quantity is for a Factory Tray of (20) Motors.
2005UD6G.68 New Sanyo Denki, Ball Bearing, 2 Phase 42MM Square (1.65 inch sq.), 5.3 OHM, 1.8 Degree Step (200 Steps per Revolution), Stepper / Stepping Motors, Part Number 103H5208-10U41. Each bid quantity is for One (1) Motor. You may bid / buy any number, up to the total quantity available above.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.