air compressor 13 cfm for sale, brand-new and used.

Jaguar Gravity Feed Spray Gun The Jaguar J100H is a much lower cfm gun if you have a smaller compressor. Features the same great atomization as the JSLP, but with less compressor. Only 6-8 cfm required, which is in the range of most smaller shop compressors.

SCHULZ REFRIGERATED AIR COMPRESSOR DRYER Protect your pneumatic equipment with this high-quality SCHULZ dryer. Moisture can damage your air tools and cause rust in your air lines. Environmentally Friendly R134a/R407C Refrigerant9 - 13 CFM

Heres a Bank of Three Medo in series switched on a mounted Plate barely used MEDO VP0625-V1014-P2-0511 vacuum pump for grabs. This pump runs on 115VAC, 50-60Hz, 1.4A. It is VERY quiet, and can pull 9.84in Hg.

This equipment was used in a clean, laboratory setting and was well-maintained. Lab is closing down, so the unit is no longer needed. Unit is fully functional.

Pump, Vacuum, 1.5 HP GAST 4Z470 Mfg Model No. 2567-V108 New old Stock - selling as-is MSRP $1237.00

Trade Show Air Compressor - Like new, only used in Trade Shows. Retails for $1,299. Spedifications:

See this on Falcon Power's website http://www.falcongenerator.com/GAC250

Super Quiet, ROLAIR Quality, Single Stage, Oilless, One Cylinder, Ball Bearings,Cast-Aluminum Cylinder, Stainless-Steel Reed Valve, Low-Amp Draw - 4.6 Amps. Features: Super Quiet, ROLAIR Quality, Single Stage, Oilless, One Cylinder, Ball Bearings,Cast-Aluminum Cylinder, Stainless-Steel Reed Valve, Low-Amp Draw - 4.6 Amps. Motor Description: 1/2 HP, 3400 RPM, Low-Amp Draw, Manual Overload Protection, 115 Volt, 60 Hz, Heavy-Duty/Industrial-Grade with Ball Bearings for Greater Durability.

Model 6 System Type Base Unit Market Industrial / Lab Displacement (50 Hz) 1.77 cfm (50 l/min) Displacement (60 Hz) 2.12 cfm (60 l/min) FAD @ Max Pressure (50 Hz) 1.13 cfm (32 l/min) FAD @ Max Pressure (60 Hz) 1.31 cfm (37 l/min)

Ingersol-Rand Super Duty Pneumatic Impact Wrench Model Number ING383 - 2925P3Ti Titanium, 1-inch drive.  Almost new, I ran it in both connections on my mid sized compressor.  It ran fine and sounde