Arduino Rtc Ds1302 Real Time Clock Module For Avr Arm Pic With Cr2032 Battery

US $220

Hong Kong, China
Jan 29th

Open on mobile:
QR code

OTHER HOT ITEMS IN OUR SHOP Product Details New DS1302 Real Time Clock Module PCB Board for AVR ARM PIC With CR2032 Battery Article-Nr.:5400387 Product Details: DS1302 real time clock module Condition: New Indication: Real-time clock with energy calculations before 2100 seconds, minutes, hours, day, week, month, year capacity, as well as the ability to leap year adjustment 1. Serial I / O ports such a way that a minimum number of pins 2. Wide operating voltage range 2.0-5.5V 3. 2.0V, operating current of less than 300nA 4. Read / write clock or RAM data transfer mode, there are two single-byte and multi-byte transfer mode transmission character set 5. 8-pin DIP package or an optional 8-pin SOIC surface mount package under 6. Simple 3-wire interface 7. Vcc = 5V and TTL compatible 8. Optional industrial temperature range of -40 to +85 9. Dual power tubes used for the main power supply and backup power supply Parameters: 1. PCB single panel, size: approx. 44mm * 23mm * 1.6mm 2. With four positioning holes, diameter 3.1mm 3. Backup battery is genuine celestial CR2032, Voltage 3V, current 260mAh, non-rechargeable batteries 4. Crystal 32.768KHz, Japan imported crystal, matching capacitance 6pF, size 2 * 6mm 5. DS1302 is made large 8-pin DIP chip, chip below IC socket for easy replacement and swap chips 6. Module operating voltage compatible 3.3V/5V, can be connected with 5V and 3.3V microcontroller 7. Working temperature: 0°--- 70° 8. PCB is single sided board Feature: DALLAS DS1302 is the clock chip which contains a real-time clock/ calendar and 31 bytes of static RAM, via a simple serial interface to communicate with the microcontroller. Real-time clock/ calendar circuit provides seconds, minutes, hours, days, weeks, months, years of information, the number of days per month and leap year automatically adjust the number of days. Clock operation by AM / PM indicator decided to use 24 or 12 hour format. DS1302 between the microcontroller can simply adopt the way synchronous serial communication port only used three lines: (1) RST Reset (2) I / O data lines (3) SCLK Serial Clock. Clock / RAM read / write data in a byte or up to 31 bytes of character set type communication. DS1302 work to maintain low power consumption data and clock information when power is less than 1mW Wiring methods (procedures in order to provide an example, you can access any IO port, modify the port definition in the program can be): VCC -> +5 V/3.3V GND -> GND CLK -> P02 DAT -> P01 RST -> P00 Color: show as pictures PLS NOTE that due to lighting effects, monitor's brightness / contrast settings etc, there could be some slight differences in the color tone of the pictures and the actual item! Note: 1. VCC and GND Do not reversed, it would burn the chip 2. C51 MCU P0 port requires pull-up resistor, if your device does not have a pull-up resistor you can connect it to other ports data lines Package Included: 1 x DS1302 Module 1 x CR2032 Battery Powered By just-the-one

Condition:

New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...

Brand

See Description