Autoclave Ritter M7 Sterilizer Speedclave Midmark Tattoo Dental Veterinary Salon

US $1,299.00

  • Saint Petersburg, Florida, United States
  • Mar 5th
This is a used Ritter M7 autoclave that has been cleaned, calibrated, and tested.  We received it non working conditioning and diagnosed it and repaired it.  The unit is running in some of the pictures so you can see it up to temperature.  I cleaned out the reservoir and chamber and inspected all wiring connections.  It is in great working condition and comes with tray rack, and 1 large tray.  Another tray can be ordered for you by a medical dealer. The outside of the unit looks ok but you can see some wear on it.   Our Process: We repair autoclave of almost all types, makes, and models. In effect of doing this we run into a lot of working and non working units.  Some of these units become parts machines and some are what we call rebuild able cores.  The good rebuild able cores are usually more rare as most doctors will use the unit to about its max.  We diagnose every unit that comes in the door.  We then deem it to be one of the other.  The ones that are rebuild able are repaired and then we replace the parts that fail the most frequently. We open up and clean out all the solenoids, valves, check all the wiring, and connections to make sure their is no corrosion or debris that may make the units fail.  Once the repair of the unit is done we move on to testing.  All repaired units are then tested extensively (15 cycles at least).  If there is one failure in any of the cycles we send the unit back and it starts the entire process over.  When a unit finishes testing and checks out good then it is pictured and listed on eBay.  Once a purchase is made and payment is received we pull the unit down and run complete cycles for the entire day.  With dry time included each cycle is about an hour long, so it gets tested about 8 more times.   Has been fully cleaned inside and out  Has been fully calibrated to temperature and pressure specifications NEW PRESSURE GAUGE NEW DOOR GASKET NEW SEALS NEW PAINT JOB NW RESERVOIR COVER NEW BELLOWS NEW ATTACHING HARDWARE "Ready To Be Put To Work" This Ritter M7 autoclave is ideal for the active medical clinic, industrial lab, dental practice, veterinary facility, or tattoo shop. The stainless steel chamber is great for sterilizing liquids, media, instruments, glassware, soil or waste products. The unit will work well for smaller facilities or a backup autoclave for larger installations. The quick cycle time can generate fast turnaround for large volume requirements that you would find in a nail salon, tattoo establishment or manufacturing process. 2.4 Gallons (9 Liters) Holds 2 trays Cycle time: From 3 to 30 minutes depending on item material (Wrapped instruments approx: 15 minutes) Overall Size:         Width: 13-5/8" (34.5 cm)         Length: 18-1/8" (46 cm)         Height: 12-7/8" (32.5 cm) Chamber Size:         Diameter: 7-1/2" (19 cm)         Length: 15" (38 cm) Large Tray Size:         Width: 5-5/8" (14.3 cm)         Length: 12" (30.5 cm)         Height: 7/8" (2.22 cm) Small Tray Size:         Width: 4-1/8" (10.5 cm)         Length: 12" (30.5 cm)         Height: 7/8" (2.22 cm) Unit Weight:         32 lbs (14.5 kg) Electrical:         115 Volts, 1150 Watts, 60 Hz, 10 Amps M7 SpeedClave Features: Safety Door The safety door on this autoclave automatically seals when pressurized and will not allow the operator to open the door until the chamber is safely depressurized. Temperature Regulator The temperature regulator allows the operator to preset the temperature at a desired setting between 250? F (121? C) and 270? F (132? C). This control, acting as a thermostat, cycles the heating element on and off. Temperature Gauge The temperature gauge indicates the temperature inside the chamber. The gauge is graduated in two-degree increments from 80? F (26.7? C) to 270? F (132? C). Low Water Cut-out Switch The low water cut-out switch prevents “dry burning”. The M7 autoclave will operate only when there is enough water present, which prolongs the life of the heating element. A pilot light is on when the heater is on and cycles on and off during normal operation. Cycle Timer The cycle timer regulates sterilization time from 0 to 30 minutes and automatically turns the M7 off when the sterilization cycle is complete. This prevents over-sterilization thus extending the service life of your instruments. The next day it is packaged and shipped out.  All units will ship no later then 3 days of receiving payment but in most cases it is in 2 days.   We ship anywhere in the continental United States.  If you have any questions or if you are in need of repairs for an autoclave please contact us at 727-644-3331.  "Over 20 years in Autoclave and Dental repair" ClaveDynasty LLC  "The sale of this item may be subject to regulation by the U.S. Food and Drug Administration and state and local regulatory agencies. If so, do not bid on this item unless you are an authorized purchaser. If the item is subject to FDA regulation, I will verify your status as an authorized purchaser of this item before shipping of the item."
Very Clean Runs Perfect, Barely Used, Ready To Work, New parts.
Brand Ritter Speedclave
Country/Region of Manufacture United States
Model M7

Directions

Similar products from Sterilizing Equipment & Autoclave Machines

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies