Double Bit Holder Fits Dewalt 12v & 20v Max Drill & Impact Driver

US $240

  • Bowmanville, Ontario, Canada
  • Nov 20th
DUAL BIT CLIP FITS ALL DeWALT 12 & 20 VOLT MAX LITHIUM TOOLS (DRILLS, HAMMER DRILLS, IMPACT DRIVERS), THAT HAVE A MOUNTING SLOT FOR EITHER A BIT CLIP OR BELT HOOK. ***BITS SHOWN IN PICTURE  NOT  INCLUDED This is a non oem part but fits and performs very well on either side of the tool.  I have tested it on basically the whole line of 12 & 20 volt tools with all battery combinations.   (over 500 sold in the past 90 days) On one particular tool with the small DCB203 20V xr battery it was a little tight to install the battery onto the tool with the clip on it.  I simply made a couple quick passes to the edge of the clip with a flat file and it fit much better.  No other issues found. Your clip will come with two screws of different lengths, use whichever works best on your tool, making sure that the screw does not penetrate too deeply into the tool and cut into the side of the battery.  You may wish to use the longer screw first to draw everything into place, then, if found to be too long, remove it and use the shorter screw as your permanent fastener.   HINT: IF YOU DON'T USE A BELT CLIP WHY NOT INSTALL ONE OF THESE ON EACH SIDE OF YOUR TOOL.  CARRY 4 BITS TOTAL ALL ATTACHED TO YOUR TOOL. I think these will be a great accessory to add to your tool.  Give them a try!  Not satisfied for any reason simply send it back in an envelope for a full refund.

Directions

Similar products from Drills & Drivers

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies