Auction is for a Ridgid 18 Volt 1/2" Drill (R86007) and a Ridgid 18 Volt Impact Driver (R86030). They were part of a combo that I purchased a few years ago but didn't need these because I already had a DeWalt drill and impact driver. Both of these have been sitting on a shelf in my basement since I purchased them.
THIS IS A YANKEE # 10 RATCHET SCREWDRIVER BY NOTH BROTHERS OF PHILADELPHIA , PA. IT IS IN FINE WORKING CONDITION WITH NO RUST. IT HAS A SINGLE SLOTTED TIP, FORWARD AND BACKWARD MOTION AND LOCKS IN POSITION.
NEARLY AS NEW MAKITA BFT040F CORDLESS TORQUE CONTROL SCREWDRIVER, PLUS 2 MAKSTAR BATTERIES & CHARGER, AND TORQUE SETTING TOOL. SETTABLE FROM 1 THROUGH 3.5 Nm TORQUE. PREVIOUS ITERATION OF CURRENT MODEL# BFT044FZ.
DUAL BIT CLIP FITS ALL DeWALT 12 & 20 VOLT MAX LITHIUM TOOLS (DRILLS, HAMMER DRILLS, IMPACT DRIVERS), THAT HAVE A MOUNTING SLOT FOR EITHER A BIT CLIP OR BELT HOOK. ***BITS SHOWN IN PICTURE NOT INCLUDED This is a non oem part but fits and performs very well on either side of the tool. I have tested it on basically the whole line of 12 & 20 volt tools with all battery combinations.
This non oem part fits any DeWalt 12 or 20 volt tool using flat top lithium ion batteries that have a mounting slot for a bit clip or belt hanger. ( Not for old 12 & 18 volt tools with pod style batteries ) Your dual bit holder will come as shown in second picture and will include a washer & 2 screws of different lengths. Please use whichever screw works best on your particular tool, making sure that it doesn't penetrate too far into the tool housing.