gage 8 for sale, brand-new and used.

Here is a new, never used Starrett #829-C small hole gage. Range .300-.400". (7.6-10.2mm) Hardened ball measuring surface with two point contact.

Here is a new, never used Starrett #829-A small hole gage. Range .125-.200". (3.2-5.1mm) Hardened ball measuring surface with two point contact.

This is an Engineering Thickness Feeler Gauge / Taper Gauge / Wire Gauge from Products Engineering Co. USA, similar to the Starrett 245 model. And, yes it does look like someone spilled some coffee on it....

Up for auction is a 579A telescopic gage made by.... The Ls. Starrett Co.

Satisfaction Guaranteed. You are buying a lot of more than 130 pieces of:Starrett No. 667M Series 12" THICKNESS GAGE / FEELER STOCK You will receive: 11 pieces 0.03mm No.

INQUIRE ABOUT LARGE QUANTITIES!!! UNBELIEVABLE LOW PRICE!!! &n

Here is a good used Vintage Starrett #479 U.S Standard sheet & Plate Iron & Steel Gage. This gage is especially designed for hard use in rolling mills and other places where constant measurements must be taken. U.S.

Here is a good used Starrett #710 ball and diameter gage, radius gage. This gage is used by tool and diemakers to check roughing and finishing cutters. Covers almost the entire range of diesinkers requirements and measures 29 full diameters from 1/8"-1" in steps of 32nds of an inch.

LISTING IS FOR A USED BT40 END MILL HOLDER

LISTING IS FOR A USED BT40 END MILL HOLDER

LISTING IS FOR A USED BT40 END MILL HOLDER

LISTING IS FOR A USED BT40 END MILL HOLDER

LISTING IS FOR A USED BT40 END MILL HOLDER

DZ BRAND CAT40 1/4" X 4" GAGE LENGTH SOLID END MILL HOLDER/ADAPTOR

DZ BRAND CAT40 1 1/4" SOLID SIDELOCK END MILL HOLDER 4 1/8" GAGE LENGTH