Jet Jwbs 18 Woodworking Bandsaw With Defect - Model 708750b

US $8100

Bessemer, Alabama, United States
Jun 5th

Open on mobile:
QR code

Unused with defect Qty. (1) Jet JWBS-18 Woodcutting Bandsaw purchased in October of 2004, uncrated and placed on the "dolly" seen in photo (1). The photos provided are as follows: 1.) Machine - front 2.) Right Side & Wheel Well Misalignment 3.) Back 4.) Left Side 5.) Bottom Wheel & Top Wheel 6.) Motor & factory pigtail 7.) Blade Guides 8.) Table - top image is table face side & bottom image is table underside 9.) Accessories box - fence, miter gauge, re-saw pin & nuts / bolts 10.) Blade tension adjustment & adjustment for upper blade guide height 11.) Owner's Manual 12.) Cosmetic marks, either as rust marks, scratches or paint chips, as follows: a.) Rust on left front corner of case w/ dimensions: 1/2" x 1-1/4" b.) Rust on left side - 3/8" x 3/4" c.) Parallel marks - 1/2" apart with a length of 2" d.) Chips on machine case where the blade passes thru at housing throat. e.) Rust on the machine case near upper blade guide adjustment. The model number is 708750B and the serial number is 40819142. The saw has a 1-1/2 HP motor and is factory wired for 120 VAC. The saw, purchased from Woodcraft store 511 in Pelham, Alabama. The machine is shown in Photo 2 as a full height shot (left Image) and as a close-up of the misalignment of the upper & lower wheel well boxes (Right Image). The gap between the boxes, as indicated with the 4-foot level, is 1/2 inch. This results in the blade running off wheel center on both wheels. For the bottom wheel, the blade center runs outboard of wheel center 1/8 inch. For the top wheel, the blade center runs inboard of wheel center 3/16 inch. When I took delivery of the machine, I did not immediately uncrated it. It lay, in-crate, for approx. (2) months after purchase. The misalignment was not immediately known. The cosmetic marks seen in photo 12 were present as "bubbled" paint spots and chipped areas when the unit was uncrated. The buyer, following the OEM Jet owner's manual, will have to complete the assembly of the bandsaw. All the items / accessories are present from the original 2004 purchase date. The OEM 3/4 x 6 TPI blade is unused. The table & fence system are unused. The machine does run and tracks with its OEM 3/4 x 6 TPI blade. Due to the cost of most hardwood lumber species and need for useful space, I am auctioning this JET JWBS-18 Bandsaw AS IS. Refund or Return not possible. Local pick only with assistance available for loading. PayPal is method of payment. The buyer has 24 hours to make payment or the bandsaw will be relisted for new bids. The buyer has 2 days to take delivery after payment or the payment will be refunded. There is room at the saws storage location for the buyer to retrieve the machine using (1) long wheel based 1/2 ton pickup truck or passenger vehicle with pull behind single axle trailer. The single axle trailer bed length is not to exceed 16ft. There is NOT sufficient room for multi-axle vehicles or fork trucks. The bandsaw measures (inches): 29 wide x 72 tall x 20 deep with a NET weight of 157 kg.