US $130
Condition: |
Used: An item that has been used previously. The item may have some signs of cosmetic wear, but is fully
operational and functions as intended. This item may be a floor model or store return that has been used. See the seller’s listing for full details and description of any imperfections.
...
|
Manufacturer | Starrett |
Model | 161-D | ||
Brand | Starrett |
Directions
Similar products from Clips & Jaws
Machinist Tool: Mixed Lot of Clamps
MACHINIST TOOLS LATHE MILL 2 Machinist Parallel Clamps for Set Up Hold Down
LATHE CLAMP DOG, 1-7/8" BETWEEN SCREWS, PROBABLY ARMSTRONG OR WILLIAMS
ALL AMERICAN TOGGLE PLIER CLAMPS MODEL 80-5102 6 PCS
Toolmakers' Parallel Machinist Clamps Like Starrett NO.161
Kant-Twist Welding Clamps 1" T handle V GROOVES IN JAWS STRONGER THAN C CLAMPS
LOT OF 2 Cam Clamps - Carr Lane
6 Machinist Clamps, Metalworking Tool, Tools
4 Machinist Parallel Clamps, Metalworking Tool, Tools
Machine Handle - Clamping Locking Lever
C-CLAMPS HARGRAVE 3 NO.41 CLAMPS (2)
C-CLAMPS WILLIAMS WILTON 404 CLAMPS (2)
C-CLAMPS HARGRAVE 6 & 4 NO. 41 (2)
People who viewed this item also vieved
150TG SINGLE-ANGLE TOOLHOLDER COLLET 1-1/8" #6040
Parallels Boxed Set of 4 matched pairs NEW
Parallels Boxed Set of 10 matched pairs NEW
Vintage Milling Clamp and Spiral Step 3/4 Stud machine table mill tooling finger
VINTAGE SMALL MACHINIST VISE JIG FIXTURE
PANA-VICE with Suction/ Articulating Base with Circuit Board Clamps
Vintage Mini-Vise for Watch/Metalworking. C&E Marshall Co.
JACOB 5/64 TO 1/2 INCH DRILL CHUCK WITH KEY (A)
Buck Chuck Jaw Set of 6 for 6in Buck Chuck
Buck Chuck Jaw Set of 3 for 6in Buck Chuck No. 6538 Commonly used on Hardinge
HARDINGE TAIL STOCK CENTER T-800?
HARDINGE TAIL STOCK CENTER T-800
Dead center for metal lathe bolt on
5c hardinge brothers collet index fixture with chuck
Vintage Pair of Dial Indicator Snug Clamps 5/16" X 1/4" - 5/16" X 1/8"
Magnetic Transfer Machinst V Block marked
VINTAGE ROTARY TABLE INDEX MILLING DRILLING extra plates PLATES
Bridgeport Rotary Table TailStock, Center (for vertical position)
Used Haas SC0HC Servo Control Box Programmable 4th 4 Axis rotary
Kennametal SS200FC188888 Collet Chuck
MACHINIST TOOLS * VALENITE COLLET CHUCK CAT 50 / TG 100 (V50CT-10SG-35) +
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.
Accept All Cookies