US $130
Condition: |
New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is
applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details.
...
|
Manufacturer | Carr Lane |
Directions
Similar products from Clips & Jaws
Lot of 2 L S Starrett Toolmaker Machinist Parallel Clamp No. 161-AA
50" Clamp & Cut Edge Saw Guide Woodworking DIY Application Swivel Pad 66581
Machinist Tool: Mixed Lot of Clamps
MACHINIST TOOLS LATHE MILL 2 Machinist Parallel Clamps for Set Up Hold Down
LATHE CLAMP DOG, 1-7/8" BETWEEN SCREWS, PROBABLY ARMSTRONG OR WILLIAMS
ALL AMERICAN TOGGLE PLIER CLAMPS MODEL 80-5102 6 PCS
Toolmakers' Parallel Machinist Clamps Like Starrett NO.161
Kant-Twist Welding Clamps 1" T handle V GROOVES IN JAWS STRONGER THAN C CLAMPS
L. S. Starrett Co. Set of 2 Machinist Parallel Clamps 161-D
6 Machinist Clamps, Metalworking Tool, Tools
4 Machinist Parallel Clamps, Metalworking Tool, Tools
Machine Handle - Clamping Locking Lever
C-CLAMPS HARGRAVE 3 NO.41 CLAMPS (2)
People who viewed this item also vieved
150TG SINGLE-ANGLE TOOLHOLDER COLLET 25/32 #6031
LOT of +100 MILLING MACHINE TABLE CLAMP WORK HOLDER TOOLS step boring mill STUDS
Parallels Boxed Set of 4 matched pairs NEW
Parallels Boxed Set of 10 matched pairs NEW
Vintage VomCleff & Co. New York Hand Vise Machinist Tool Made in Germany 1 5/8"
VINTAGE SMALL MACHINIST VISE JIG FIXTURE
PANA-VICE with Suction/ Articulating Base with Circuit Board Clamps
SUPREME 5/64 TO 1/2 INCH DRILL CHUCK (C)
JACOB 5/64 TO 1/2 INCH DRILL CHUCK WITH KEY (A)
Buck Chuck Jaw Set of 6 for 6in Buck Chuck
NEW CLEVELAND USA HIGH SPEED #5MT LATHE DEAD CENTER with 60° INCLUDED ANGLE
HARDINGE TAIL STOCK CENTER T-800?
HARDINGE TAIL STOCK CENTER T-800
Acorn Butterfield Thred-Rite Dies Lot and Die Tools
Ultra Thin Precision Parallel Set
Vintage Pair of Dial Indicator Snug Clamps 5/16" X 1/4" - 5/16" X 1/8"
VINTAGE ROTARY TABLE INDEX MILLING DRILLING extra plates PLATES
Bridgeport Rotary Table TailStock, Center (for vertical position)
Used Haas SC0HC Servo Control Box Programmable 4th 4 Axis rotary
**NEW* * SANDVIK COROMANT, AA3B27-50 25 085, Basic Drill Holder, CAT50, ER25
Kennametal SS200FC188888 Collet Chuck
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.
Accept All Cookies