mx controller for sale, brand-new and used.

This auction is for an Emerson/Control Techniques Cable, Part Number AX4-MX-010. This is a Command/Feedback cable that connects an Emerson Axima Controller to their MX Series Servo Drives. It is 10' long.

This auction is for an Emerson/Control Techniques Cable, Part Number AX4-MX-005. This is a Command/Feedback cable that connects an Emerson Axima Controller to their MX Series Drives. It is 5' long.

ZENITH MX200 MX150 MX250 ATS CONTROLLERS All CAN USE THESE MODULES You can use for replacement or to add feature like remote source monitoring, or pre-transfer signaling. GE Zenith part number K-1265 is made of Phoenix Contact base UMK-SE 11.23-1 with two FINDER Type 44.62s relays on board. These relays are rated 12V and 330OHM, which makes them very hard to find.

This is just one component of an ATS- NOT a complete transfer switch. GE Zenith part number 50W-1000 is the harness between a MX controller, and a R/T box. It carries low-voltage sensing and control wiring and is the source of the MX power.

This cable has been made by a third party, and tested with Zenith MX ATS control equipment. Required for selection of factory options and full memory reset of controllers and controller password codes. Plug this key into bottom of MX controller, power up, and press buttons 1 and 4 together to access menu features.

Description:

MCU: STM32F103RCBT6, a 32-bit ARM Cortex M3 microprocessor Clock Speed: 72 MHz 128 KB Flash and