red security door for sale, brand-new and used.

These are new in an opened box Description: Micro, Black Sides SampleVolume: 0.7 mL Cover Type: Flat Lid Pathlength,mm: 10 ExternalDimensions, mm: 12.5W x 12.5L x 45H InternalDimensions, mm: 2W x 10L Unit:

This is used and in unknown condition. It has a large scratch across the meter and the batteries are coroded. It does power up and sound a low battery alarm.

This is used and it works properly, it has a 20 place rotor with 11mm holes. 13,000 RPM fixed speed. The interior is a little grungy.

This is used and in good condition. It heats properly and charges like it should. With the charging base.

This is unused in an open box, Foxboro PH Orp sensor 871PH-1X1A. It does appear to have been on the shelf a while. See the item photos above for the actual contents of the auction and the exact condition of the item elements.

This is an unused single stage cylinder regulator in new condition. It has no tank fitting adapter. 12 to 125 PSI output.

This is used and in good condition. It has been tested and is working properly. It is 340mL and rated at 40 volts, 6 amps.

This is used in very good condition. It was made for an 8 liter culture vessel and is about 8 1/4 inches in diameter (adjustable) and three inches wide. It operates on 120 Volts AC.

This is used and is in good condition. It has some staining on the fabric mantle but not bad. It is for a 250mL round bottom flask.

Lightly used and in good condition. It heats properly and looks good too. 20 See the item photos above for the actual contents of the auction and the exact condition of the item elements.

This is a used temperature measuring transducer by Phoenix Contact. It is configured for a three wire PT100 RTD with a range of 0-100C with a 4-20 mA output. It has a very small footprint and is DIN rail mountable.

This is used and it has some kind of residue on the outside of it. I tried windex and alcohol and they didn't work. The inside is clean and it has been stored with a plastic cap on it.

This is a used calibration weight, the foam protector in the box is deteriorating and will need replacement. (pieces stick to the weight) The weight is in good condition. This is an E2 grade weight suitable for calibrating other calibration weights or balances as low as .01mg.

These are in good used condition. The current calibration is good, 20 gram calibration weight in the factory case. The case condition is a little rough but serviceable, these are class 4 weights.

This is used and untested. E1A Card with cable. See the item photos above for the actual contents of the auction and the exact condition of the item elements.

This is used and untested. RS232 stepper controller # 38285. See the item photos above for the actual contents of the auction and the exact condition of the item elements.