torque bench for sale, brand-new and used.

Atlas Copco Tensor DS Drive D311-DS7 Advance controller system with ETV DS7-40-10S Electric Nutrunner & Speed controller Type DS311-DS7, 8433 0812 33 100-120, 220-240VAC , 200W 50-60Hz 25A

var itemNumber = window.ebayItemID ?

GCI Torque arm originally from the closed down Ford Ranger Plant here in MN. Originally held an electronically controlled torque wrench for Assembly of components. You could fit many different tools into the tool mount.

You are bidding on a Yaskawa servo amplifier # SGDG-04GT along with the add on programmable motion controller SMC3010. The SGDG-04GT can drive motors of 100~750W rated output. Basic Specifications Input Power Supply Main Circuit1

Previously owned. Has less then normal wear for a tool type. It has wear but the major is mostly from sliding around the top of the work bench. Impacts awesome w/ free shipping to the lower 48 states only.

var itemNumber = window.ebayItemID ?

var itemNumber = window.ebayItemID ?

var itemNumber = window.ebayItemID ?

AuctivaEasson3Mill799Ver1

Snap on Electronic torque tester 40-400 #QC1ETT400 Designed to be a sturdy, low cost tester, these electronic torque testers can be placed on the wall in the factory or on a bench to allow operators to test torque wrenches or power tools without having to leave their station. Integral transducer and sturdy housing allow mounting in virtually any position. Integral Transducer: Full bridge strain gauge, 350 ohms, 1500 µE, 3mV/V F.S., 3.75V excitation.

This 8JS 3 phase synchronous motor is used, but was only used in a test bench setup. It has not been used on any equipment, and has very, very low hours. It is in excellent condition.

PMI Kollmorgen Servodisc Motor with Tachometer & Encoder S6M4H / S6T 00-S0644-012 - 8mm Shaft Diameter - 21 in-oz torque - Tach 0.75 V/krpm This auction is for one used PMI Kollmorgen Motor. Each Motor has a Tachometer and a Lucus Ledex Quadrature, 600 count per rev square wave encoder. These usints were removed from several decommissioned systems and all have some dirt and a little surface corrosion from storage.

Torque Systems Snapper You are bidding on One Used Torque Systems Snapper Industrial Servo Motor Model MT-5030-056GA which appears to be in Good Working condition. We do not know the rated operating range for this motor. We tested it on 6 and on 12 Volts DC using a small bench power supply.

PITTMAN 12V DC Motor GM9413-5 This motor is larger than most Pittman Motors that I have seen on ebay. I have connected to a bench 12 volt power supply and it ran fine. Timed rotation of shaft at about 4 rpm.