transmission tool for sale, brand-new and used.

The innovative Solar Transmission and BTU Power Meter demonstrates both the solar transmission percentage of your window. Can also be used to measure the approximate solar heat gain co-efficient value for windows. A great tool for a salesman who does window demonstrations in the home.

Description:

USR-K1 RS232 Serial to Ethernet Converter TCP IP Module-UDP and TCP Client Mode Q15847

Check out my other items! This filter is NOS from an instrument manufacturer. The filter separates a band of UV and Blue, by reflecting it at right angles to the incidence light, while transmitting nearly all of the Cyan, Green and Red.

INTRODUCTION Ever want to build your own weather station? This anemometer is made of shell, wind cups and circuit module. It has built-in photovoltaic module, industrial microcomputer processor, and standard current generator.

The Jacobs CAT V 50 end mill tool holder is designed to hold up to a 1-1/2-Inch shank cutting tool. It has 4.6-Inch projection and is prebalanced to 15,000 RPM. The Jacobs CAT V 50 end mill tool holder is used for heavy duty cutting and general milling.

The Jacobs CAT V 50 Shell/Face mill tool holder is designed to hold up to a 1-1/2-Inch shank cutting tool. It has a 2.4-Inch projection and is prebalanced to 8,000 RPM. The Jacobs CAT V 50 Shell/Face mill tool holder is designed for heavy duty cutting and face milling.

NEW Brother FAX575 Fax/Phone/Copier 512KB Memory CID 11-9/10inx10-1/2inx13-

New Ryobi P212 ONE Plus 18V Cordless 2-Speed Hammer Drill (Bare Tool) Torque IV clutch override for quick mode changes from drilling to driving 1/2 in. single sleeve keyless chuck with spindle lock for quick, easy bit changes 2-speed transmission and 24 position clutch for high torque applications MagTray magnetic holder for screws and bits GripZone over mold for added comfort Part Number P212 Item

The Jacobs NMTB 40 Shell/Face mill tool holder is designed to hold up to a 40-mm shank cutting tool. The Jacobs NMTB 40 Shell/Face mill tool holder is prebalanced to 8,000 RPM. The Jacobs NMTB 40 Shell/Face mill tool holder is designed for heavy duty cutting and face milling.

Did you ever buy a crimp tool and then later become disappointed with the purchase? I have. Did you ever begin the crimp sequence and then realize you were not actually fully prepared, and needed to stop before full compression was completed, only to realize you must complete the crimp cycle to release the tool?

What is PIC-EK PIC-EK is a MCU development system for the PIC starters. It supports over 250 PIC microcontrollers,which comes with over 400 sample programs based on 16F877A, 16F74, 16F77,16F914, 16F887,18F4550, 18F452, 18F4520 etc.It is loved by beginners and hobbyists, as well as professionals, and used in education and development.