This auction is for the Alloy or Pot Metal pulley as pictured. It is the drive pulley for a 4" Jointer of unknown Brand or Make. It is about 2" diameter 1/2" bore About 1 1/8" Thick overall.
Gates TL18H100 PowerGrip Sintered Steel Timing Pulley, 1/2" Pitch, 18 Groove, 2.865" Pitch Diameter, 1/2" to 1-1/4" Bore Range, For 3/4" and 1" Width Belt currently using a 5/8 bore with key not included.
This is a cast idler pulley for the backside of a 3L, 4L or A series V-Belt. It measures 5 3/4" (5.75") OD with a 5/8" (0.625") wide face. The hub is on ball bearings and has a 1/2" (0.5") ID bore and the hub is 3/4" (0.75") deep.
This auction is for the Very Heavy Alloy or Pot Metal wide pulley as pictured. It is about 6" diameter 5/8" bore with a key slot on 1 side only. The edge is about 1 1/2" wide outside and 1 1/8" wide for a flat belt Wear and Tear Dust and dirt but in good working condition.
This is a 3" Pot Metal or alloy Motor Pulley with a 1/2" diameter bore takes 1/2" wide belts. It mounts with a set screw that is inside the pulley (under the belt) . The pulley is about 5/8 " thick.
This is a 2" Pot Metal or alloy Motor Pulley with a 1/2" diameter bore takes 3/8" wide belts. It mounts with a set screw that is inside the pulley (under the belt) . The pulley is about 11/16 " thick.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.