12 tooth gear for sale, brand-new and used.

Up for bid is a Folwer involuted metric gear tooth pitch gauge in used condition. There is some dried oil on the toll but it's otherwise unused and has been sitting in a toolbox for many years. It has 7 leaves and ranges in sizes from 6-12 mm A little bit of steel wool or just some lacquer thinner would clean this thing up like new and it can be had for much cheaper here then other online retailers

BRONZE DRIVE GEAR AND SHAFT FOR 7 X 12 METAL CUTTING BANDSAW 1980s-90s VERSION Bronze Drive Gear and Shaft for 7 x 12 Metal Cutting Bandsaw This is shaft is for the early version from the 1980's and early 90's With a 17mm shaft .669" Overall length 4.091"

TEKTON 1492 1/2-Inch Drive Quick-Release Swivel Head Ratchet, 72-Tooth Round Head Awesome Access Made for tight spots, the round head swivels continuously through 270 degrees to find the perfect angle of attack and the 72-tooth gear needs just 5 degrees of swing arc to operate. Lock-On Drive Tang Sockets lock onto the quick-release drive tang to make sure they don't fall off in deep, dark places or get stuck on fastener heads.

You get the exact ratchet pictured. It is in great condition and works perfect. It has no etchings or engravings.

Bosch DCB760 Daredev

Nice small high torque gear motor for animation or similar. Rated for 50hz but operates okay on 60hz 220 volt at about 0.75 rpm. Don't know torque rating but I can't stop the gear with my bare hand when running.

I describe this lot "Manufacturer Refurbished" due to different depth of sharpening on some cutters. Items are new & never been used, this is just unsignificant imperfection of USSR factory sharpening.Despite this, material quality was very high those days, at least better than chinese HSS nowdays.According to my experience these cutters' form relieved to allow resharpening many times.Feel the difference (1st photo: my cutters; 2d - used cutter resharpened many times): &

This is a new, no box or instructions. They are 12 volt DC 96-1 dual shaft motors. The output shaft is .249 x .690 with a roll pin hole.

I describe this lot "Manufacturer Refurbished" due to different depth of sharpening on some cutters. Items are new & never been used, this is just unsignificant imperfection of USSR factory sharpening.Despite this, material quality was very high those days, at least better than chinese HSS nowdays.According to my experience these cutters' form relieved to allow resharpening many times.Feel the difference (1st photo: my cutters; 2d - used cutter resharpened many times): &

BRAND NEW BAILEY MODEL 71151, GP-F20-08-S9-C, HYDRAULIC GEAR PUMP. FRAME SIZE CU. IN REV0.48 SHAFT