15 hp motor for sale, brand-new and used.

Brand new in the box.

EM7045T 7.5//5HP, 3520//2930RPM, 3PH, 60//50HZ, 213T

STOCK PHOTO, PICTURE IS NOT ACTUAL ITEM EM3615T-8 5HP, 1750RPM, 3PH, 60HZ, 184T, 3642M, TEFC, F1

CEWDM3550 1.5HP, 3500RPM, 3PH, 60HZ, 56, C, 3528M, TENV, F

STOCK PHOTO, PICTURE IS NOT ACTUAL ITEM VEM31120 1.5HP, 3490RPM, 3PH, 60HZ, 56

EM7056T 15/20HP, 1465/1765RPM, 3PH, 50/60HZ, 256T

Sale is for (1) NEW DAYTON 2C820 BLOWER 8 15/16" DUST COLLECTOR WITH USED LEESON MOTOR 3/4 HP 3450 RPM 230/460 The 2C820 blower housing is brand new the Leeson Motor is used we are a authorized Leeson dealer so this has been tested This has light scratches shown in the photo's

Gast Oil-less Piston Vacuum Pump & Compressor, 7HDE-10-M855X With a 1-Phase Marathon 2 HP 220 Volt Motor Compare to model: 7HDE-10-M850X (Motor: 110-220-240V @ 50 Hz)

This MADE IN USA motor is fully functional. It has been cleaned and re-oiled. It has low hours as a fan motor.

3 phase 1 horsepower motor with slow start control box and switch. This setup is stock from Rockwell and came off an older Delta industrial lathe. Used but well cared for, tested and working great.

Emerson 1 HP Hazardous Location TEFC Motor 230 - 460 Volt / 3 Phase / 1745 RPM .875" Shaft CATALOG # X1S2BCR MSRP:$ 967.00

General Motors GE AC motor 1/4 hp, 115V 1725 RPM Model # 5KC35JN12. Used condition with new cord. Tested and works.

SPEC. NUMBER: 36F227Y155 CATALOG NUMBER: L3609T FL AMPS: 28/14 208V AMPS: 15.5 BEARING-DRIVE-END: BEARING-OPP-DRIVE-END: DESIGN CODE: DOE-CODE: -- FL EFFICIENCY: ENCLOSURE: FRAME: 184T HERTZ: 60 INSULATION-CLASS: F KVA-CODE: K SPEED [rpm]: 1725 OUTPUT [hp]: 3 PHASE: 1 POWER-FACTOR: 85 RATING: 40C AMB-CONT SERIAL-NUMBER: -- SERVICE FACTOR: 1.00 VOLTAGE: 115/230 This motor has never been used. It has some surface rust on the shaft from setting

Up for sale is a new old stock baldor electric motor.

EHM2535T-8 30HP, 1770RPM, 3PH, 60HZ, 286T, 4052M, OPSB, F1

EHFM2523T-8 15HP, 1765RPM, 3PH, 60HZ, 254T, 3938M, OPSB, F2

FEATURES: All stainless steel tank and dispersion head assembly. The tank is water jacketed to control the friction induced heat energy generated by the Stator/Rotor particulate shearing/dispersing process. The mill is fully plumbed with inline cooling water regulator and gauging, for connecting directly to your chilled water process piping or municipal water supply.