2 hp motor 3 phase for sale, brand-new and used.

TurboJet Max II Dual Speed, 3-Phase Motor The TurboJet Max II negative air machine is a compact workhorse for residential and light commercial duct cleaning. It’s hard to believe a 22.5” wide cabinet can provide 2700 CFM at 5” static pressure, a full-size 12” inlet, 3-stage HEPA filtration, soft start and will run at 13 or 17 amps and has a lifetime warranty. This is performance that is found in units twice its size and weight.

[ Century HSQ1202 2 HP 3450 RPM 208-230 V Pool Pump Motor

[ Marathon Motors 056T11D5302 1/2 HP 1140 RPM 208-230/460 V General Use Motor

[ Century H853V2 1-1/2 HP 1725 RPM 200-230/460 V Belt Drive Motor

New pump...was to be installed but found was sent wrong voltage...cord cut approx 12' long, ready for hard wire or new plug. 80WQ0.55-4P, 230V 15000GPH max flow, max head: 23ft, 3/4hp, 230V,single phase, 5.5Amps motor full load, 3" discharge, 33ft long water proof power cable. Size: 14"X12"X20.5" Specification: Speed: 1750RPM (nominal) Solid Handling: 2" Max Ambient Temp: 104F (40C) Continuous 140F(60C)Intermittent Max.

The Rotofera is Suhner’s most popular full size flexible shaft machine. The service life of the machine is measured in decades even under constant daily use. The reliable three phase induction motor runs more quietly and more efficiently than either conventional pneumatic or electric tools.

The Rotomax 1.5 is Suhner’s most advanced flexible shaft machine and has a service life measured in decades even under constant daily use. A reliable, electronically controlled induction motor runs more quietly and more efficiently than conventional pneumatic or electric tools. And by separating the drive unit from the tool, the tool can be made smaller, lighter and more powerful; thereby increasing productivity and reducing operator fatigue even in continuous use.

The Rotar is Suhner’s most powerful full size conventional flexible shaft machine. The service life of the machine is measured in decades even under constant daily use. The reliable three phase induction motor runs more quietly and more efficiently than either conventional pneumatic or electric tools.

Used CLIPPER brand Industrial masonry/brick saw. 14" Dia. blade maximum size.

[ Dayton 1/3 HP 3450 RPM 115/208-230V General Purpose Motor

[ Baldor Electric VEM3538 1/2 HP 1735 RPM 230/460V General Purpose Motor

[ Delhi SD24-XPF 24 In 115/208-230 V Direct Drive Panel Exhaust Fan

[ Dayton 30 In Dia 3 HP 200-230/460V Tubeaxial Fan

EMERSON MOTOR C-PHASE "NEW SURPLUS" CAT: 8P7P2CCR MODEL: BG98 STK. 34 WEIGHT: 160 LBS FRAME: 213TC TE ENCLOSURE 7.5 HP 460 VOLT 3 PHASE FREIGHT ITEM ONLY. Shipping Info

Grieve Model 333 Large Capacity Electric Batch Oven You can easily convert this oven from 3 phase to to Single Phase Grieve Industrial helps people do that all the time if you are not handy at doing it yourself. Also, you can cheaply upgrade yourself to modern digital pid controls over mfg analog controls. Used industrial batch oven.

Unit is new unused, hard to find no longer available from grainger we purchased a few of these for a project, upon our testing the motor turned out to be more powerful than we needed, Technical Specs Phase1 Hz60 Shaft OrientationParallel 3/4" dia Nameplate RPM 90 Input HP 1/4 Gear Ratio 19:1 Full Load Amps4.6 EnclosureODP

UP FOR SALE HVAC/R MOTOR , HERE ARE THE SPECS : Motor Application HVAC/R Motor Sub Application Condenser Fan Motor Design PSC Motor Enclosure Design Totally Enclosed Air-Over HP 1/2 Number of Speeds 1 Nameplate RPM 1075 Frame 48YZ Voltage

This is a Vintage Strong running 1/4 Horsepower General Electric motor from a Wood Lathe. Comes as pictured with an on/off switch mounting bracket and clips and Bolts as pictured. Has a 1/2" diameter shaft flat sided about 1 3/4" long 1/4 Horsepower 115 Volt 60 Hz 1725 RPM 5.6 amp single phase Reversible Currently wired clockwise (Right handed at shaft end).