"Occupying a floor space of just 65" x 32.5 inches ( 1650 x 825 mm) and with an 18" x 6" (450 x 150 mm) table capable of moving 19 inches (480 mm) longitudinally and 6.75 inches (170 mm) in traverse the 540 grinder was ideally suited to most smaller toolroom jobs. The cross slide was supported on two V ways with a feed rate of 0.007" to 0.07" (0.175 to 1.75 mm) per minute at each reversal of the longitudinal stroke.
Click HERE to see all of my Height / Depth Gauges This is 6” depth gauge is made in the USA by Products Engineering Company. This is an easy-to-read gauge which allows precise depth measurements in small holes and slots. The b
Click HERE to see all of my Height / Depth Gauges This is 6” depth gauge/protractor made in the USA by Products Engineering Company. This is an easy-to-read gauge which allows precise depth measurements in small holes and slots and also doubles as a pr
This is a rare find, new old stock Rohm type 350 reversible hard stepped 4 jaw set for 12" ES-315-4 combination lathe chucks. 90mm length x 24mm width x 67.5 mm height. Part 139671, matched set of 4 stamped Rohm serial number 5434 numbers 1, 2, 3, and 4.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.
