LOT OF 1 (one), SIFAM/SELCO P/N SP150-250, BLACK COLLET KNOB WITH NUT CAP. DIM: 15 MM at BASE 12 MM at TOP 13.5 MM HEIGHT SHAFT: 1/4 INCH Just screw down the nut to tighten onto a 1/4" OD shaft. The pictures show the complete knob, the parts to the knob, and the sixth picture shows the knob installed on a pot (NOT included).
Set of 4 Knobs Pulled from vintage equipment, set of 4 knobs is made of grey plastic with white arrow indicator. Measures 1.16" in diameter at skirt x 0.74" tall. Hole for 1/4" shaft (notice that it will accommodate both a regular pot shaft and a more unusual D-shaped one.
Tektronix Calibration Knob Set Pulled from used equipment, this Tektronix dual-stacked calibration knob set features a clear plastic skirt on the bottom knob. Lower knob is 1.25" in diameter at skirt x 0.855" tall, hole for 1/4" shaft. Upper knob 0.391" in diameter x 0.46" tall with hole for 1/8" shaft.
Set of 3 Knobs Pulled from vintage equipment, set of 3 knobs is made of black plastic with aluminum trim insert in top. Knobs measures 1/2" in diameter with hole for 1/4" shaft. 2 set screws on side.
Total of four (4) black 1" pointer control knobs for 1/4" shaft, with 2 set screws. Three (3) of the knobs are NOS new in package Raytheon # 70-4-2. Plastic bag packaging has shelf wear.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.
