For your consideration Masonry Bit, 3/4" x 36", 4 Cutter, Carbide Tipped Bit This bit was used to drill 6 holes 12" deep in green concrete. Some minor surface oxidation(see photo) Has been coated with light lubricating compound.. Overall length 36".
Many people have asked me to supply just the kit to convert a CDV-700 from a wired probe to a BNC connected probe. This is that kit with all the electrical and tooling needed to accomplish the first step in the LENi conversion of a ENi brand CDV-700, or just to add the versatility of a connector to any CDV-700 so different probes can be used on it. INCLUDES Drill bit to drill a 21/64" hole in the panel for BNC connector installation.
5 LB Grab Bag of 90 Degree Right Angle Drill Bits Unsorted, will contain some dull bits, but most will be sharp and ready to use. Approximately 360 Bits Made for use in 90 degree quick change drill motors, but can be used in 3/8" chuck drills also. Most of these have been resharpened
Holds 36 #3 Morse Taper drill bits. 6" Deep 12-3/4" Wide The pockets are tapered for alignment.A #3 Morse Taper measures approximately .938 large end to .778 small end. Made from PVC with MDF legs.
You are looking at a lot of masonry spline drill bits sizes are 1-14x16, 1" x 23, 1-1/2 x 22, and 1/2 x 36. If you have any questions please ask!! Must go!!
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.