Joyce/Dayton Ball Jack Screw Inverted Style HWB65 - 10 - INV - T4 5 - Ton Jack Screw Dia : 1 - 1/2 " x 14" long Jack Height : 8 - 5/8" Mounting Plate : 6" x 8 - 1/4" x 1/2" Male end Clevis pin : End Plate to End of Clevis pin : 5 - 5/16" Wormgear ratio : 6:1 , Worm Shaft turns for 1" travel : 5 ,
Johnson 5/8-3/4" snatch block.9-3/4" sheave. 19" OAL. Pin stays in(won't fall out) good working clevis hole is 1-1/8." there is a little wobble rust & pitting
Tractel Tirfor Griphoist TU-32 This was only used a few times and was shelved indoors. Wire rope is included and is also in very good condition with no broken stands or damage.The manual, handle and an extra shear pin are also included. Additional items also included: (x1) 7/8" clevis shackle bolt with nut (8.5 ton), (x2) forged eye bolt with shoulder 1" x 8" (8500 lb).
N O S CLEVIS END PLATED STEEL SHAFT / LINK 1" OP X 7-7/8" LONG CLEVIS DEPTH IS 1-1/8" OVER ALL 1-5/8" TO CENTER OF PIN HOLE [ size 5/16" hole 3/8" slot & 1/2" hole with 3/8" slot other end ] CLEVIS ARE OFF SET [about 2:00 ]
Numatics hydraulic cylinder, 5/8" shaft/6" shaft exposed at rest, 9.5" extended=3.5 inch stroke 3"x4 5/8" mounting plate with (4) .338" holes on shaft end, 1/2" clevis pin on opposite end Please contact me if you have questions about this item. Thanks for looking.
NEW OEM ALLIANZ-JOHNSTON/GOBAL CYLINDER. PART NUMBER 302344 SPS IT IS;(MEASURED WITH A TAPE MEASURE)18-3/4 OVERALL LONG FIXED END; 1/2 PIN HOLE, FROM END TO CENTER OF PIN HOLE IS 3/4, IT IS 3/4 WIDE ROD END; IS CLEVIS STYLE 1/2 PIN HOLES, FROM END TO CENTER OF PIN HOLES I
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.