Hi, up for sale is 5 sets of small, aluminum, "2 hole" pins. These measue 1-1/8" O.D., and will fit holes from 1/2" to 1-1/16" , and are very light weight, but strong. These have a 45 degree taper with 1/2"-13 removable threads, 2" long, with knurled nuts.
Hi, up for sale is 5 sets of small, aluminum, "2 hole" pins. These measue 1-1/8" O.D., and will fit holes from 1/2" to 1-1/16" , and are very light weight, but strong. These have a 45 degree taper with 1/2"-13 removable threads, 2" long, with knurled nuts.
Hi, up for sale is 5 sets of Mini, aluminum, "2 hole" pins. These measue 1-1/8" O.D., and will fit holes from 1/4" to 1-1/16" , and are very light weight, but strong. These have a 45 degree taper with 1/4"-20 removable threads, 2" long, with knurled nuts.
Now with Knurled nuts! Hi, up for sale is one lot of 5 sets of 1-1/8 inch O.D., aluminum, "2 hole" pins. These measue 1-1/8" O.D., and will fit holes from 1/4" to 1-1/16", and are very light weight, but strong.
Designed for control and calibration of angle measuring devises, as well to check the angles of products. Angular measures have holes for attaching accessories, tightening tiles in blocks. Made in USSR.
You are bidding on a very nice Parlec 50 Taper Test Alignment Bar, Cat No. P50-20TB18 with documented calibrated ground slots for setting lengths. Features 50 Taper 2.000" diameter Constructed of alloy steel for long, durable service life Hardened to RC 56-60 for long service life Made in the "USA" Shiny taper with black oxide finish for the best combination of accuracy and durability.
YOU ARE PURCHASING THE PICTURED ISCAR TOOL HOLDER. IT IS NEW. IT IS LABELED: ISCAR MG 12.7 - 08C16 IF YOU HAVE ANY QUESTIONS JUST SEND ME AN EMAIL, OR GIVE ME A CALL AT 937-475-3068.
This is a newly machined 47/37 transposing gear set which converts your 8 TPI lead screw to a 2.5 mm pitch. The thread’s crest-to-crest or lead error is only 0.02% or about 0.0025 inch for a one-foot long threaded rod. The transposing gears are under 3 inches in diameter leaving lots of room for closing the gear cover.
This is a new set of precision ground Tool Maker Mill Angles made by Jenkins Tool Co..These are some of the most versatile pieces of tooling you can have . They can be used for milling ,drilling ,grinding and inspection purposes .They are made by hand from A-2 tool steel and hardened 56-58 rc. Ground square and parallel to within +/- .0002.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.