600 watts for sale, brand-new and used.

Click on top picture for magnified viewing I obtained these from a local estate, Six Glas - Col heating mantles in excellent condition, they look to have never been used.There is also one roughly 4' power cord that works with all the mantles. Also an aluminumbodied heating element marked Fisher Scientific. This is not my field of expertise so I will give the best details (also many pics) I canto describe.

Freq. Range 1-11 GHz Model No. CA2336-35A Coupling 35 + 1.5 Freq.

this dipping tank is 1 quart 600 watts 120 volts dipping area 5" D x 3.5" DEPTH

Description Dehydrator Food Converga-Flow Drying System 13 by 13 by 10-inch Adjustable Thermostat This Dehydrator dries fruit, vegetables, and jerky in hours instead of days. The unit's patented Converga-Flow drying system forces air down the exterior pressurized chamber, then horizontally across each individual tray, converging in the center, for fast, even, and nutritious drying. Flavors don't mix, and there's no need to rotate the trays.

GREETINGS YOUR BIDDING ON ONE LOT OF THREE NEW/BOXED Bussmann LPJ-125SP and One AJT125 Ferraz Shawmut

USA Daily Deals AmpFlow E30-150 Brushed Electric Motor, 12V, 24V or 36 VDC, 5600 rpm

New Page 3 Welcome to e-techstore -- Your on-line Buddy to provide satisfactory service Read before you bid: We accept P

~ ACCUBANKER ~

Used but in good working condition Ohmite part # TAP600K10R 10 Ohms 10% 600 Watts Chassis mount, heat sink mount Screws included See the datasheet for details Qty - 2 Shipping Information:

One: (#1 of 2) New Old Stock and still in original Blister Pack - Ungar Soldering Iron element/tip # 535 - Rated at 27 Watts and has the 1/8" threaded end for use with the "modular" tips* - this is listed for 600 - 650 F degrees. * I have some of these 1/8" NOS NIB tips listed on eBay also..... Please see the other Ungar elements & tips I have listed on eBay - some are unused but open, these others all have boxes or blister cases.

One: Unused Ungar Soldering Iron element/tip - Rated at 23 1/2 Watts and has a four-sided square tip made of Copper. I am not sure about the temp of this tip but I believe it is 550 - 600 F - I can not be 100% sure about this...... I tested all of these tips at one point so they may show some "blackening" of the tips which happens once they are heated up fully.

The Model 350B The attenuator functionally tested good on all steps, but is not calibrated. Attenuation to 0 to 110 db in 1 db steps 600 ohm impedance 5 watts continuous duty Frequency response accumulative error at 100 kc approx. 1db in 50db The attenuator is mounted in a small wooden cabinet.