air cylinder tubing for sale, brand-new and used.

From 2013 Freightliner with 30,000 miles, thats why we think the hours of this unit are supposed to be low. It has light scratches on the cover. All the wireing and control units from inside the truck are included.

(one) chemical slurry mixing blending pump transfer skid, includes slant bottom intake hopper, 30" x 28" x 36" deep with 12" opening at top, Effector high and low limit proximity sensors, hopper bottom electric vibrator, 9’ long x 4" diameter auger screw feeder that dumps into a 16" x 18" x 50" high pre-mix tank compartment with Mamec Oy mixer agitator, model HDS 5.5/1000, 6.5 KW, 1150 rpm, 440/480 vac, direct drive with dual stagger tooth impellers.

Runs and operates perfectly. I only use recreational fuel and was just run out with new gas installed. Oil changed also and ready to go now.

I purchased this unit used and have tested it for performance, it works great, and appears to have been used very little. Included is 150' of 300 psi hose and a Graco gun. The following are the factory specs: GH 733 Roof Rig Ga

I have this LoLo #LKT-45G, Natural Gas Manual Tilt 45 Gallon Kettle with Lift-Off Lid. This was installed in a school in November 2013 and was only used a short time because the Kitchen Manager did not like it. It was removed in the May 2014 where it was stored before being listed for sale here.

JMR TBH-250U Electric Hydraulic Tube & Pipe Bender TBH-250U The JMR Electric/Hydraulic Tube Bender is a precision machined unit that offers large capacity, a fast hydraulic system, and a NEW auto-stop feature. Just clamp the stop block anywhere along the billet engrave

Honda Generator. Low hours.